Delphi TA2586 Steering Tie Rod End - Right Outer

Delphi TA2586 Right Outer Tie Rod End

Delphi TA2586 is a steering tie rod end built for the right outer position on select Nissan Rogue and Rogue Select models. It combines a coated steel housing, pre-greased construction, and a dust boot to support consistent steering response in everyday driving.

Key Features

• Fits 2008-2013 Nissan Rogue, right outer
• Fits 2014-2015 Nissan Rogue Select, right outer
• Pre-greased design with no grease fitting
• Dust boot included with chloroprene rubber construction
• Steel tie rod and steel housing with coated finish
• Bent, standard replacement design
• Mounting hardware included
• Clockwise thread direction at both ends

Detailed Description

This Delphi steering tie rod end, part number TA2586, is engineered as a standard replacement for the right outer steering position. It features a female end 2, threaded stud design, plastic bearing material, and a bent profile that matches the application geometry used on the Nissan Rogue and Nissan Rogue Select. Delphi applies OE-focused dimensional and material analysis to support fit and function across aftermarket steering service.

Delphi tests steering components across extreme temperature ranges and extended salt-spray exposure to evaluate durability in demanding conditions. For shoppers searching for a right outer tie rod end for 2008-2013 Nissan Rogue or 2014-2015 Nissan Rogue Select, TA2586 provides a direct replacement option with the correct thread specifications and included dust boot.

This part cross-references MOOG Chassis Products ES800582 for the same application.

Common Problems This Part Can Address

• Loose or vague steering feel at the front right wheel
• Clunking or play from a worn outer tie rod end
• Uneven tire wear caused by steering linkage wear
• Steering pull or poor alignment retention after service
• Damaged dust boot or contaminated steering joint

Installation Notes and Tips

Confirm right outer fitment before installation on the Nissan Rogue or Rogue Select. After replacement, a professional wheel alignment is recommended to restore steering geometry and tire wear characteristics. Verify thread direction, stud dimensions, and mounting points against the removed part before final tightening.

Quality Assurance

Delphi uses OE-based engineering and validation methods for its steering portfolio, including dimensional and material checks and environmental testing for temperature and corrosion exposure. TA2586 is built as a standard replacement steering tie rod end for the specified applications.