Delphi TA2629 Steering Tie Rod End - Inner

OE-Style Front Inner Tie Rod End

Delphi TA2629 is a standard replacement steering tie rod end for the front inner position. It is built for 1989-1994 Nissan Maxima and 1991-1996 INFINITI G20 applications, with OE-focused dimensional and material analysis to support proper steering geometry and fit.

Delphi applies OE safety technology and aftermarket steering expertise to this part, with testing that includes extreme temperature exposure and salt-spray durability evaluation. The result is a front inner steering component made for direct replacement service on Nissan Maxima and INFINITI G20 steering systems.

Key Features

• Front inner steering tie rod end
• Male end 1 gender
• Standard replacement grade
• Mounting hardware included
• No grease fitting and non-greaseable design
• No dust boot included
• OE-based dimensional and material analysis for fit consistency
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray during durability testing

Detailed Description

Delphi TA2629 is engineered for steering service where precise front inner linkage fit is required. It is a direct replacement tie rod end for 1989-1994 Nissan Maxima and 1991-1996 INFINITI G20 models, helping restore steering connection at the inner position. This part cross-references MOOG Chassis Products EV285 for the same application.

Delphi’s OE-oriented manufacturing approach focuses on compatibility between original equipment dimensions and aftermarket replacement geometry. That makes TA2629 a practical choice when replacing worn steering components on a Nissan Maxima or INFINITI G20 and maintaining consistent steering response.

What This Part Helps Address

• Loose or vague steering feel from worn inner tie rod components
• Steering play caused by joint wear
• Uneven front-end response during lane changes or turns
• Clunking or knocking from steering linkage wear
• Alignment instability related to degraded steering hardware

Installation Notes and Tips

Install TA2629 at the front inner steering position only. Verify thread direction, linkage condition, and alignment settings before returning the vehicle to service. Because this part does not include a grease fitting and is not greaseable, routine service is not performed through the joint. Always confirm fitment against the vehicle’s steering configuration before installation on 1989-1994 Nissan Maxima or 1991-1996 INFINITI G20 applications.

Quality Assurance

Delphi uses OE safety technology and extensive testing to validate steering parts for real-world durability. TA2629 is evaluated for extreme temperature resistance and corrosion exposure, with dimensional and material analysis used to support OE-style fit and performance.