Delphi TA2676 Steering Tie Rod End - Left Outer

OE-Style Steering Tie Rod End

Delphi TA2676 is a standard replacement steering tie rod end built for front left outer applications on select Nissan and Chevrolet vehicles. It combines OE-focused dimensional control with a pre-greased, coated steel design to support precise steering response and consistent fitment.

• Steering tie rod end for front left outer / left outer position
• Pre-greased design; no grease fitting included
• Coated steel housing and steel tie rod construction
• Dust boot included with chloroprene rubber (CR) material
• Mounting hardware included
• Female end 2 with clockwise thread direction at both ends
• Standard replacement grade for OE-style service

Fitment and Application

Compatible with 2018-2020 Nissan Kicks, left outer; 2011-2019 Nissan LEAF, left outer; 2013-2019 Nissan NV200, left outer; 2013-2019 Nissan Sentra, left outer; 2015-2018 Chevrolet City Express, left outer; 2015-2017 Nissan Juke, left outer; and 2011-2014 Nissan Juke, left outer with female threads. Delphi TA2676 is also a direct cross-reference for MOOG Chassis Products ES801171 and Beck/Arnley 101-7674 for the same application.

What This Part Helps Address

• Loose or imprecise steering feel at the front left outer wheel position
• Clunking or play caused by worn tie rod end joints
• Uneven tire wear related to steering linkage wear
• Boot damage that can expose the joint to contamination
• Replacement needs on Nissan Kicks, LEAF, NV200, Sentra, Juke, and Chevrolet City Express steering systems

Installation Notes

Verify the vehicle’s application tab before ordering, especially for the 2011-2014 Nissan Juke, which requires female threads. This part is not adjustable and is not greaseable, so alignment should be checked after installation. Confirm thread direction, stud type, and position match the original component before service.

Quality Assurance

Delphi applies OE engineering practices to its aftermarket steering portfolio and validates parts through extreme temperature testing from below -40 degrees C to over 120 degrees C, plus 720 hours of salt spray exposure. Dimensional and material analysis is used to support OE-to-aftermarket compatibility for Delphi TA2676.