Delphi TA2697 Steering Tie Rod End - Inner

OE-Style Front Inner Tie Rod End

Delphi TA2697 is a standard replacement steering tie rod end for the front inner position on select Mercedes-Benz SUVs and crossovers. Built with Delphi OE engineering and dimensional analysis, it is made for accurate fitment and consistent steering response on the applications listed below.

Compatible with Mercedes-Benz R350, GL350, GL450, GL550, ML350, ML450, ML550, ML63 AMG, GL320, ML320, R320, R550, R500, and R63 AMG front inner steering applications. Delphi TA2697 is a direct-fit steering component for restoring worn inner tie rod service points.

• Standard replacement steering tie rod end
• Front inner position
• Male end 1 gender
• Mounting hardware included
• No grease fitting included
• Non-greaseable design
• No dust boot included

Key Features

• OE-focused design for dimensional and material compatibility
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray testing for corrosion resistance validation
• Built for Mercedes-Benz steering systems that require a front inner tie rod end
• Delphi TA2697 supports precise steering linkage service on listed vehicles

Detailed Description

Delphi applies OE safety and steering expertise to this aftermarket tie rod end, using material and dimensional analysis to match the original part as closely as possible. The TA2697 is engineered for the front inner steering location and is listed for 2006-2013 Mercedes-Benz R350, 2010-2012 GL350, 2007-2012 GL450, 2008-2012 GL550, 2006-2011 ML350, 2010-2011 ML450, 2008-2011 ML550, 2007-2011 ML63 AMG, 2007-2009 GL320, 2007-2009 ML320, 2007-2009 R320, 2008 R550, 2006-2007 ML500, 2006-2007 R500, and 2007 R63 AMG. This part cross-references MOOG Chassis Products EV800376 and Beck/Arnley 101-5799 for the same application.

What It Helps Address

• Loose or vague steering feel from a worn inner tie rod end
• Steering play or delayed response at the wheel
• Uneven tire wear related to steering linkage wear
• Clunking or knocking from the front steering system
• Failed inspection due to steering component wear

Installation Notes and Tips

Install at the front inner steering position only on the listed Mercedes-Benz applications. Verify thread engagement, alignment settings, and steering linkage condition during service. Because no grease fitting is included and the part is non-greaseable, it is typically installed as a sealed replacement component. Replace related worn steering parts as needed to maintain proper alignment and steering feel.

Quality Assurance

Delphi validates this steering component through extreme-temperature testing and extended salt spray exposure, along with OE-level dimensional and material analysis. That process supports consistent fit and performance for Mercedes-Benz steering service applications. Part number TA2697 is built as a standard replacement for the listed vehicles.