Delphi TA2707 Steering Tie Rod End - Left Outer

Delphi TA2707 Front Left Outer Tie Rod End

Delphi TA2707 is a steering tie rod end built for front left outer applications on select BMW and Rolls-Royce vehicles. It combines OE-focused dimensional control with a coated steel housing, pre-greased construction, and a dust boot to support precise steering response and long-term service life.

Key Features

• Steering tie rod end for front left outer position
• Delphi part number TA2707
• Pre-greased design with no grease fitting required
• Coated steel housing and steel tie rod material
• Dust boot included for added joint protection
• Mounting hardware included
• Bent, non-adjustable design
• Female end 2 with clockwise thread direction

Detailed Description

Delphi TA2707 is a standard replacement steering tie rod end engineered for OE-style fit and steering accuracy. Delphi applies dimensional and material analysis to help ensure proper compatibility with the original steering geometry, while testing parts through extreme temperature exposure and extended salt spray conditions. This makes it a practical choice for BMW 528i, 535i, 550i, 740i, 750Li, M5, and related models, as well as Rolls-Royce Ghost, Wraith, Dawn, Phantom, and Cullinan applications listed for the left outer position. This part cross-references MOOG Chassis Products ES800914 for the same application.

What It Helps Address

• Loose or imprecise steering feel at the front left outer tie rod end
• Clunking or play caused by wear in the steering linkage
• Uneven tire wear related to steering component looseness
• Steering response issues from a worn outer tie rod joint
• Corrosion-related service concerns in exposed steering hardware

Installation Notes and Tips

Verify the vehicle application by year, make, model, and left outer position before installation. The TA2707 is not adjustable, so alignment should be checked after replacement to confirm steering wheel center and toe settings. Confirm thread size, thread pitch, and stud orientation against the original part before assembly on BMW 640i, 650i, 750i, and Rolls-Royce left outer steering applications.

Quality Assurance

Delphi uses OE-based engineering practices for its aftermarket steering portfolio and subjects parts to temperature extremes below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray testing. That validation supports consistent performance for the TA2707 across the listed BMW and Rolls-Royce fitments.