Delphi TA2708 Steering Tie Rod End - Right Outer

Delphi TA2708 Steering Tie Rod End

Delphi TA2708 is a standard replacement steering tie rod end built for the front right outer position on select BMW and Rolls-Royce applications. It combines OE-based dimensional analysis with materials and sealing details that support precise steering response and consistent fitment.

Key Features

• Part number: TA2708
• Front right outer steering tie rod end
• Pre-greased design with no grease fitting
• Dust boot included for joint protection
• Coated black finish with steel housing and steel tie rod
• Clockwise thread direction on both ends
• Mounting hardware included
• Standard replacement grade

OE-Style Steering Fit

Delphi applies OE-focused engineering to its aftermarket steering portfolio, using dimensional and material analysis to match the original part as closely as possible. This tie rod end is tested across extreme temperature ranges and salt-spray exposure to support durability in demanding road conditions. It is a direct-fit steering component for vehicles such as the BMW 528i, BMW 535i, BMW 550i, BMW 740i, BMW M5, and Rolls-Royce Ghost, with fitment listed for the right outer position. The Delphi TA2708 is also cross-referenced to MOOG Chassis Products ES800915 for the same application.

What It Helps Address

• Loose or vague steering feel at the front end
• Clunking or play from a worn outer tie rod end
• Uneven tire wear caused by steering linkage wear
• Steering wheel off-center after suspension service
• Front right outer steering linkage replacement on BMW and Rolls-Royce models

Installation Notes and Tips

Verify the vehicle application by year, make, model, and position before installation. This part is specified for the front right outer/right outer location, and both ends use clockwise thread direction. Because the tie rod end is pre-greased and not greaseable, no routine fitting service is required. After installation, a professional wheel alignment is recommended to restore steering geometry.

Quality Assurance

Delphi validates steering components through OE-oriented testing, including exposure to temperatures below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray. That testing, along with OE dimensional and material analysis, supports consistent compatibility and performance for BMW 528i, BMW 535i, BMW 550i, BMW 740i, BMW M5, and related applications covered by TA2708.