Delphi TA2720 Steering Tie Rod End - Left Outer

Delphi TA2720 Front Left Outer Tie Rod End

Delphi TA2720 is a steering tie rod end built for the front left outer position on select Mercedes-Benz applications. It combines OE-based dimensional and material analysis with a coated steel housing, pre-greased construction, and a dust boot to support precise steering response and consistent fitment.

Compatible with Mercedes-Benz E300, E350, E550, E280, E500, S430, S500, and E320 applications, this Delphi tie rod end is a standard replacement for the front left outer steering position. The TA2720 part number is commonly searched for Mercedes-Benz steering repair and OE-style replacement needs.

• Steering tie rod end for front left outer placement
• Pre-greased design with no grease fitting required
• Dust boot included to help protect the joint
• Coated steel housing and steel tie rod construction
• Bent style with threaded stud design
• Mounting hardware included
• Black finish
• Standard replacement grade

OE-Based Steering Replacement

Delphi applies OE-focused engineering to its aftermarket steering portfolio, using dimensional and material analysis to improve part-to-vehicle compatibility. The TA2720 is built with a 14.0 mm end thread diameter, 1.5 mm thread pitch on the end 2 side, clockwise thread direction on both ends, and a 7.913 in. stud-center-to-end length. Additional construction details include a plastic bearing material and chloroprene rubber dust boot material for the steering joint assembly.

This part cross-references Beck/Arnley 101-6514 for the same application.

Common Steering Issues It Can Address

• Loose or vague steering feel at the front left outer wheel position
• Clunking or play from a worn outer tie rod end
• Uneven tire wear caused by steering linkage wear
• Steering pull or wandering after suspension inspection
• Failed dust boot or contaminated steering joint

Installation Notes

Fits 2008-2009 Mercedes-Benz E300, Left Outer; 2006-2009 Mercedes-Benz E350, Left Outer; 2007-2009 Mercedes-Benz E550, Left Outer; 2007 Mercedes-Benz E280, Left Outer; 2004-2006 Mercedes-Benz E500, Left Outer; 2003-2006 Mercedes-Benz S430, Left Outer; 2003-2006 Mercedes-Benz S500, Left Outer; 2004-2005 Mercedes-Benz E320, Left Outer.

After installation, the steering geometry should be checked and aligned to factory specifications. Verify thread direction, stud seating, and position before final tightening. The TA2720 part number should be matched to the vehicle’s left outer steering application before service begins.

Quality Assurance

Delphi subjects steering components to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure testing. These validation steps support OE-level performance expectations for Mercedes-Benz E300, E350, E550, E280, E500, S430, S500, and E320 steering service applications.