Delphi TA2789 Steering Tie Rod End - At Pitman Arm or Left Outer

Delphi TA2789 Steering Tie Rod End

Delphi TA2789 is a straight steering tie rod end built as a standard replacement for select Dodge Ram trucks. It is pre-greased, greaseable, and supplied with a dust boot to support steering service on vehicles that need a direct-fit OE-style component.

Key Features

• Straight steering tie rod end for steering linkage service
• Pre-greased with a grease fitting included
• Dust boot included with chloroprene rubber construction
• Steel housing and steel tie rod material with coated finish
• Male/male end configuration
• Mounting hardware included
• Standard replacement grade

Detailed Description

Delphi TA2789 is engineered for steering applications where precise fit and durable construction matter. Delphi applies OE-level dimensional and material analysis to its aftermarket steering portfolio, and this part is tested across extreme temperature and corrosion conditions to help verify performance in demanding environments. The gray, coated steel design, threaded stud construction, and greaseable serviceability make it a practical replacement for steering wear on 1998-1999 Dodge Ram 1500, 1998-1999 Dodge Ram 2500, and 1998-1999 Dodge Ram 3500 applications listed below. This part cross-references MOOG Chassis Products ES3497 for the same application.

Vehicle Fitment

• Fits 1998-1999 Dodge Ram 1500, at pitman arm.
• Fits 1998-1999 Dodge Ram 2500, left outer, 6.50in length.
• Fits 1998-1999 Dodge Ram 2500, at pitman arm.
• Fits 1998-1999 Dodge Ram 3500, at pitman arm.

Common Issues This Part Helps Address

• Loose or imprecise steering response
• Excessive play in the steering linkage
• Clunking or knocking from worn steering joints
• Uneven tire wear caused by steering component wear
• Grease loss or contamination at the steering joint

Installation Notes and Tips

Verify the position on your vehicle before ordering, since Delphi TA2789 is listed for at pitman arm and left outer applications. Confirm thread direction, thread diameter, and overall length against the removed part before installation. After replacement, have the steering system inspected and the front end aligned as needed.

Quality Assurance

Delphi uses OE-focused engineering and validation for its steering components, including dimensional and material checks plus environmental testing for temperature and salt exposure. That approach supports consistent fitment and durability for Dodge Ram steering service.