Delphi TA2791 Steering Tie Rod End - Right Inner

Delphi TA2791 Right Inner Tie Rod End

Delphi TA2791 is a steering tie rod end built for the right inner position on select Dodge Ram van applications. It combines OE-based dimensional analysis with corrosion and temperature testing to support consistent steering response in demanding road conditions.

Compatible with 1995-1998 Dodge B1500, right inner; 1995-1998 Dodge B2500, right inner; 1995-1998 Dodge B3500, right inner; 1999-2000 Dodge Ram 1500 Van, right inner; 1999-2000 Dodge Ram 2500 Van, right inner; and 1999-2000 Dodge Ram 3500 Van, right inner with 4000lb axle(s).

Key Features

• Part number TA2791
• Right inner steering tie rod end
• Standard replacement grade
• Pre-greased with grease fitting included
• Dust boot included
• Coated black finish with steel housing and steel tie rod
• Bent design with threaded stud type
• Non-adjustable construction
• Mounting hardware included
• End 1: male, clockwise thread, 0.625 in. diameter, 18 TPI
• End 2: male, counterclockwise thread, 0.875 in. diameter, 18 TPI

Detailed Description

Delphi applies OE-focused engineering to its aftermarket steering portfolio, and TA2791 reflects that approach with careful dimensional and material analysis for fit and function. The component is built with a steel housing, steel tie rod, chloroprene rubber dust boot, and plastic bearing material, then finished with a protective coating to help resist harsh operating conditions. Delphi also subjects steering components to extreme temperature exposure and extended salt-spray testing to evaluate durability.

This Delphi TA2791 tie rod end is a direct-fit steering service part for Dodge B1500, B2500, and B3500 vans from 1995-1998, plus Dodge Ram 1500 Van, Ram 2500 Van, and Ram 3500 Van models from 1999-2000 with 4000lb axle(s). This part cross-references MOOG Chassis Products DS1010 for the same application.

Common Repair Uses

• Restores steering linkage connection at the right inner position
• Addresses looseness or play in the steering system
• Helps correct uneven tire wear caused by worn steering components
• Supports more precise steering feel and wheel control
• Replaces a damaged or corroded tie rod end on Ram van and B-series applications

Installation Notes

Verify the vehicle is equipped with the listed 4000lb axle(s) where required before ordering. Confirm thread direction, thread diameter, and right inner position match the existing steering linkage before installation. After replacement, a professional wheel alignment is recommended to set steering geometry and protect tire wear.

Quality Assurance

Delphi uses OE-based testing and material validation for its steering components, including temperature cycling below -40 degrees C and above 120 degrees C, along with 720 hours of salt-spray exposure. That validation supports consistent fitment and corrosion resistance for service use on Dodge Ram van and Dodge B-series steering systems.