Delphi TA2799 Steering Tie Rod End - Left Inner

Delphi TA2799 Left Inner Tie Rod End

Delphi TA2799 is a steering tie rod end for the left inner position on select Ford E-Series vans and wagons. Built as a standard replacement with OE-focused dimensional and material analysis, it is made for accurate steering linkage service on high-mileage Ford E-250 and Ford E-350 applications.

Key Features

• Part number: TA2799
• Left inner steering tie rod end
• Standard replacement for steering service
• Steel housing and steel tie rod construction
• Coated black finish for added surface protection
• Pre-greased with grease fitting included
• Dust boot included
• Mounting hardware included
• Non-adjustable design
• Clockwise thread direction on both ends

Application Details

Compatible with select Ford E-250, Ford E-350 Super Duty, Ford E-350 Club Wagon, Ford E-350 Econoline Club Wagon, and Ford E-350 Econoline models in the left inner steering position. Fits 2007 Ford E-250, left inner; 2003-2005 Ford E-250, left inner; 2006 Ford E-250, left inner to 09/02/2005; 2007 Ford E-350 Super Duty, left inner; 1999-2005 Ford E-350 Super Duty, left inner; 2006 Ford E-350 Super Duty, left inner to 09/02/2005; 2003-2005 Ford E-350 Club Wagon, left inner; 1995-2002 Ford E-250 Econoline, left inner; 1995-2002 Ford E-350 Econoline Club Wagon, left inner; and 1995-1998 Ford E-350 Econoline, left inner. This part number, TA2799, also cross-references MOOG Chassis Products DS1289 and ES800434 for the same application.

Why This Part Matters

• Restores steering linkage geometry when the original tie rod end is worn
• Helps reduce looseness, play, or wandering in the steering wheel
• Addresses clunking or knocking from the front steering system
• Supports even tire wear when steering components are out of spec
• Replaces a damaged dust boot or greaseable joint during steering repair

Installation Notes

Verify left inner position, thread direction, and thread size before installation. The TA2799 uses a bent design with male ends, a 22.0 mm end 2 thread diameter, and a 14.0 mm end 1 thread diameter. Because this is a steering component, a professional alignment is recommended after replacement. Confirm vehicle build date on 2006 applications noted as valid to 09/02/2005.

Quality Assurance

Delphi applies OE engineering methods to its aftermarket steering portfolio and subjects parts to temperature extremes below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray testing. That validation process supports fit, corrosion resistance, and durability for Ford E-250 and Ford E-350 steering service.