Delphi TA2807 Steering Tie Rod End - Left Outer

Delphi TA2807 Front Left Outer Tie Rod End

Delphi TA2807 is a standard replacement steering tie rod end for the front left outer position. It is built with OE-focused dimensional and material analysis to support proper steering geometry on select BMW xDrive and xi models, including BMW X1, 328i xDrive, 335i xDrive, 328xi, 335xi, 325xi, and 330xi applications.

Key Features

• Part number: TA2807
• Front left outer steering tie rod end
• Pre-greased design with no grease fitting
• Dust boot included for joint protection
• Steel housing and steel tie rod construction
• Coated gray finish
• Bent style with threaded stud design
• Mounting hardware included
• Non-adjustable, greaseable: No
• End 1 and End 2 thread diameter: 14.0 mm
• End 2 thread pitch: 1.5
• Clockwise thread direction at both ends

Detailed Description

Delphi TA2807 is engineered as a direct-fit steering tie rod end for the front left outer location. It features a pre-greased joint, chloroprene rubber dust boot, plastic bearing material, and coated steel construction to help maintain steering response and joint protection in demanding driving conditions. Delphi applies OE-level testing to its steering portfolio, including exposure to extreme temperatures below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray testing for corrosion resistance validation. This part cross-references MOOG Chassis Products ES800799 for the same application.

Vehicle Fitment

• Fits 2012-2015 BMW X1, left outer.
• Fits 2009-2013 BMW 328i xDrive, left outer.
• Fits 2009-2013 BMW 335i xDrive, left outer.
• Fits 2007-2008 BMW 328xi, left outer.
• Fits 2007-2008 BMW 335xi, left outer.
• Fits 2006 BMW 325xi, left outer.
• Fits 2006 BMW 330xi, left outer.

Common Steering Issues This Part Can Address

• Loose or vague steering feel at the front left outer linkage
• Clunking or knocking from worn steering joints
• Uneven tire wear caused by excessive tie rod play
• Steering wheel wander or poor directional stability
• Corrosion-related joint wear in exposed steering components

Installation Notes and Tips

Confirm the front left outer position before installation and verify thread direction, thread diameter, and stud style against the removed part. After replacement, perform a professional wheel alignment to restore correct toe settings and steering wheel centering. Inspect the mating steering components for wear before final assembly.

Quality Assurance

Delphi uses OE-based engineering and validation methods for its aftermarket steering parts, including dimensional and material analysis to improve part-to-vehicle match. TA2807 is tested for temperature extremes and salt spray exposure to support durability in real-world service.