Delphi TA2808 Steering Tie Rod End - Right Outer

Delphi TA2808 Front Right Outer Tie Rod End

Delphi TA2808 is a standard replacement steering tie rod end for the front right outer position. It is built with OE-focused dimensional and material analysis to help maintain proper steering response on BMW applications, including BMW X1 and BMW 3 Series xDrive models.

Key Features

• Front right outer steering tie rod end
• Pre-greased design with no grease fitting required
• Dust boot included to help protect the joint
• Steel tie rod and steel housing with coated finish
• Bent style construction
• Clockwise thread direction on both ends
• Mounting hardware included
• Standard replacement grade

Product Details

The Delphi TA2808 steering tie rod end is engineered for direct replacement use on select BMW front steering systems. It features a female end, threaded stud design, and a chloroprene rubber dust boot for added protection against road contamination. Delphi subjects its steering components to extreme temperature cycling and extended salt-spray exposure to verify durability in demanding conditions. This part cross-references MOOG Chassis Products ES800800 for the same application.

Vehicle Fitment

• Fits 2012-2015 BMW X1, right outer.
• Fits 2009-2013 BMW 328i xDrive, right outer.
• Fits 2009-2013 BMW 335i xDrive, right outer.
• Fits 2007-2008 BMW 328xi, right outer.
• Fits 2007-2008 BMW 335xi, right outer.
• Fits 2006 BMW 325xi, right outer.
• Fits 2006 BMW 330xi, right outer.

Common Repair Uses

• Restores steering linkage integrity when the outer tie rod end is worn
• Addresses looseness or play in the front right steering connection
• Helps correct steering wander or imprecise road feel
• Supports replacement after torn dust boot or joint contamination
• Helps resolve uneven steering response during turning and lane changes

Installation Notes

Verify the front right outer position before installation and confirm thread direction, thread diameter, and overall dimensions against the removed part. After replacement, a professional wheel alignment is required to set steering geometry correctly. Always inspect the adjacent steering components for wear before completing the repair.

Quality Assurance

Delphi applies OE expertise to its aftermarket steering portfolio and validates parts through dimensional and material analysis for fit and performance consistency. The component is also tested under severe temperature and corrosion conditions to support long-term durability in steering service.