Delphi TA2855 Steering Tie Rod End - Inner

Delphi TA2855 Steering Tie Rod End

Delphi TA2855 is a standard replacement steering tie rod end built for OE-style fit and function. It is engineered for front inner steering applications on select Kia models, including Optima, Magentis, and Rondo, with application-specific fitment by year and wheel configuration.

Key Features

• Standard replacement steering tie rod end for inner steering linkage service
• Male end 1 gender
• Mounting hardware included
• No grease fitting and no dust boot included
• Non-greaseable design for low-maintenance operation
• OE-focused dimensional and material analysis for fit consistency
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray during validation

Application Details

Compatible with 2007-2012 Kia Rondo, inner, with 16in or 17in wheels. Compatible with 2007-2010 Kia Magentis, inner. Compatible with 2007-2010 Kia Optima, inner. Compatible with 2005-2006 Kia Magentis, inner, from 12/01/2005. Compatible with 2005-2006 Kia Optima, inner, new design. Delphi TA2855 is also referenced for Kia Optima inner steering service and Kia Magentis inner steering service in OE-style replacement catalogs.

This part cross-references MOOG Chassis Products EV800353 and Mevotech Supreme MS90704 for the same application.

What It Helps Address

• Loose or inaccurate steering response from worn inner tie rod components
• Steering play or wandering at the front wheels
• Uneven tire wear caused by steering linkage wear
• Clunking or knocking from the inner steering assembly
• Restoration of proper toe control after steering service

Installation Notes

Verify the vehicle year, model, and wheel configuration before ordering, especially for 2007-2012 Kia Rondo applications. Inspect the steering linkage, alignment settings, and related components during replacement, and perform a wheel alignment after installation. Delphi TA2855 is supplied without a grease fitting or dust boot, so confirm the existing steering system condition before service.

Quality Assurance

Delphi applies OE engineering practices to its aftermarket steering portfolio. This tie rod end is validated through extreme-temperature testing and extended corrosion exposure, with dimensional and material checks used to support OE-style compatibility for the listed Kia applications.