Delphi TA2888 Steering Tie Rod End - Inner

OE-Style Inner Steering Tie Rod End

Delphi TA2888 is a standard replacement inner steering tie rod end built for precise steering linkage service. It is listed for select Jaguar E-Pace, Land Rover Range Rover Evoque, Land Rover Discovery Sport, and Tesla S applications, with fitment varying by vehicle position.

Delphi applies OE-level dimensional and material analysis to help match the original part’s fit and function. This Delphi TA2888 steering tie rod end is tested across extreme temperatures and salt exposure to support dependable steering performance in demanding conditions.

Key Features

• Standard replacement inner steering tie rod end
• End 1 gender: male
• Mounting hardware included
• No grease fitting included
• Non-greaseable design
• No dust boot included
• Position(s): inner, left inner, right inner; verify application tab for exact placement

Detailed Description

Delphi TA2888 is engineered for steering systems that require an OE-style inner tie rod end with accurate dimensions and material compatibility. Delphi’s aftermarket steering portfolio is backed by OE safety technology used on millions of vehicles worldwide, and this part is validated through temperature cycling below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray exposure. That testing helps support long-term durability in real-world driving conditions.

This part cross-references Beck/Arnley 101-8084 for the same application. It is a direct-fit style replacement for select 2012-2018 Land Rover Range Rover Evoque, 2015-2017 Land Rover Discovery Sport, 2012-2016 Tesla S, and 2018-2020 Jaguar E-Pace inner steering applications. If you are searching for Delphi TA2888 for a Land Rover Range Rover Evoque inner tie rod end or a Tesla S inner steering tie rod end, confirm the exact side and position before ordering.

What It Helps Address

• Excessive steering play from a worn inner tie rod end
• Loose or imprecise steering response
• Clunking or knocking from the steering linkage
• Uneven tire wear related to steering geometry wear
• Steering correction issues caused by worn linkage components

Installation Notes

Install only after confirming the vehicle’s exact steering position and side requirements. Because this part is listed for inner, left inner, and right inner positions depending on application, verify the fitment tab before installation. Mounting hardware is included, while a grease fitting and dust boot are not.

Quality Assurance

Delphi uses OE-focused engineering and extensive dimensional and material analysis to support proper fitment and performance. The part is also subjected to extreme temperature and corrosion testing to help verify durability in steering service.