Delphi TA2925 Steering Tie Rod End - Inner

Delphi TA2925 Inner Tie Rod End

Delphi TA2925 is a straight steering tie rod end built for front inner steering applications. It uses OE-focused dimensional and material analysis to support proper fit and consistent steering response on select Hyundai and Kia vehicles, including Hyundai Sonata, Hyundai Azera, Kia Optima, and Kia Cadenza.

Key Features

• Part number: TA2925
• Steering tie rod end, front inner position
• Straight design with male-to-male ends
• Adjustable construction for steering linkage service
• Steel housing and steel tie rod material
• Coated black finish for added surface protection
• Pre-greased; grease fitting not included
• Mounting hardware included
• Standard replacement grade
• Compatible with select 2011-2017 Hyundai and Kia inner steering applications

Detailed Description

Delphi TA2925 is engineered as an OE-style steering tie rod end for the front inner position. It features a steel housing, steel tie rod material, and a polyoxymethylene (POM) bearing material, along with a coated finish and pre-greased construction. The straight, adjustable design supports steering linkage service where precise thread engagement and dimensional accuracy matter. Delphi validates its steering components through extreme temperature exposure and salt-spray testing, then applies OE dimensional and material analysis to help maintain compatibility with the original steering geometry. This part cross-references MOOG Chassis Products EV800695 for the same application.

Vehicle Fitment

• Fits 2012-2017 Hyundai Azera, inner
• Fits 2014-2016 Kia Cadenza, inner
• Fits 2011-2015 Kia Optima, inner
• Fits 2011-2014 Hyundai Sonata, inner

Common Repair Uses

• Restoring steering linkage stability after tie rod wear
• Correcting looseness or play in the front inner steering system
• Addressing uneven tire wear caused by worn steering components
• Replacing a damaged or corroded inner tie rod end
• Supporting proper front-end alignment service

Installation Notes

Install on the front inner steering position only. Verify thread direction, thread diameter, and overall length against the original part before installation. Because this is an adjustable steering component, a professional wheel alignment is recommended after replacement. Confirm vehicle application by year, make, model, and steering configuration before ordering.

Quality Assurance

Delphi applies OE-based engineering and durability testing to its steering portfolio, including temperature cycling below -40 degrees C and above 120 degrees C, plus extended salt-spray exposure. TA2925 is built to standard replacement specifications for select Hyundai and Kia inner steering applications.