Delphi TA3003 Steering Tie Rod End - Left Outer

Delphi TA3003 Front Left Outer Tie Rod End

Delphi TA3003 is a standard replacement steering tie rod end for the front left outer position. It is built with a steel housing and tie rod, a coated finish, and a pre-greased design with a dust boot to help protect the joint in everyday driving conditions.

Compatible with 2013-2022 Acura ILX and 2012-2015 Honda Civic, this Delphi tie rod end is a direct-fit steering service part for vehicles that need precise front-end steering linkage restoration. The TA3003 part number is also referenced in OE-style replacement searches for Acura ILX and Honda Civic front left outer steering repair.

Key Features

• Front left outer steering tie rod end
• Delphi TA3003 standard replacement part
• Steel housing and steel tie rod construction
• Coated black finish for added surface protection
• Pre-greased design with dust boot included
• Mounting hardware included
• Female end 2 with threaded stud design
• Non-adjustable, non-greaseable configuration

Detailed Description

Delphi applies OE-focused dimensional and material analysis to its aftermarket steering portfolio, helping maintain proper compatibility between the replacement part and the original steering geometry. TA3003 is engineered for the front left outer position and uses a bent tie rod design with a chloroprene rubber dust boot, plastic bearing material, and threaded stud connection. The part measures 197.0 mm from stud center to end and uses a 14.0 mm end 2 thread diameter with a 12.0 mm end 1 thread diameter.

This part cross-references MOOG Chassis Products ES800912 for the same application. Search terms such as 2013 Acura ILX front left outer tie rod end, 2012-2015 Honda Civic left outer steering tie rod, and Delphi TA3003 replacement tie rod end are commonly used when matching this service part.

Common Steering Issues It May Address

• Excessive steering play at the front left outer linkage
• Clunking or looseness from worn steering components
• Uneven tire wear caused by steering end wear
• Steering wheel wander or poor directional stability
• Failed dust boot protection around the tie rod joint

Installation Notes and Tips

Confirm left outer fitment before ordering and verify thread direction, thread diameter, and overall length against the original part. After installation, a professional wheel alignment is recommended to restore steering geometry and tire wear characteristics. Inspect the adjacent steering components for wear before completing the repair.

Quality Assurance

Delphi subjects steering components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt-spray testing. This testing supports OE-level performance expectations for the TA3003 in daily-use steering applications.