Delphi TA3005 Steering Tie Rod End - Left Outer

Delphi TA3005 Front Left Outer Tie Rod End

Delphi TA3005 is a standard replacement steering tie rod end built for the front left outer position on select Mazda 6 models. It combines OE-focused dimensional control with a coated steel housing, pre-greased construction, and a dust boot to support consistent steering response in everyday driving.

Key Features

• Fits 2009-2013 Mazda 6, left outer
• Front left outer steering tie rod end
• Pre-greased design with no grease fitting
• Dust boot included with chloroprene rubber material
• Steel housing and steel tie rod construction
• Coated black finish for added surface protection
• Mounting hardware included
• Clockwise thread direction on both ends
• Standard replacement part number TA3005

Detailed Description

Delphi TA3005 is engineered for the steering linkage on 2009-2013 Mazda 6 applications at the front left outer position. Delphi applies OE-style dimensional and material analysis to help ensure proper fit and consistent performance, while the part is tested across extreme temperature ranges and salt-spray exposure to reflect real-world undercar conditions. The bent design, female end configuration, and threaded stud setup support direct replacement service on the specified Mazda 6 fitment.

This part cross-references MOOG Chassis Products ES800856 and Beck/Arnley 101-7392 for the same application. Delphi TA3005 is also referenced alongside other aftermarket numbers used for this Mazda 6 steering position.

What It Helps Address

• Loose or imprecise steering feel at the front left outer linkage
• Clunking or play from a worn tie rod end
• Uneven tire wear caused by steering geometry wear
• Steering response issues from damaged ball-and-socket components
• Corrosion-related wear on exposed steering hardware

Installation Notes and Tips

Verify the vehicle is a 2009-2013 Mazda 6 and confirm the front left outer position before installation. Inspect the mating steering components, alignment settings, and thread engagement during service. Because this tie rod end is pre-greased and not greaseable, no grease fitting service is required. An alignment check after replacement is recommended to restore steering geometry.

Quality Assurance

Delphi backs this steering part with OE-focused engineering practices, including temperature and corrosion testing and dimensional validation for aftermarket fitment. The TA3005 is built as a standard replacement steering component for the specified Mazda 6 applications.