Delphi TA3008 Steering Tie Rod End - Front Left Outer or Front Right Outer

Delphi TA3008 Steering Tie Rod End

Delphi TA3008 is a standard replacement steering tie rod end built for front outer steering applications on select Nissan and INFINITI vehicles. It combines OE-based dimensional analysis with materials and sealing details that support consistent steering response and proper fitment.

• Steering tie rod end for front left outer and front right outer positions
• Pre-greased design with no grease fitting for low-maintenance service
• Dust boot included to help protect the joint from road contamination
• Steel housing and steel tie rod construction with coated finish
• Threaded stud design with mounting hardware included
• Black finish, bent type, standard replacement grade
• End 1 thread diameter: 12.0 mm; End 2 thread diameter: 14.0 mm
• End 1 and End 2 thread direction: clockwise

OE-Based Steering Fit and Construction

Delphi applies OE engineering practices to its aftermarket steering portfolio, and the TA3008 reflects that approach with dimensional and material analysis focused on fit accuracy. The part is tested across extreme temperatures and salt-spray exposure to evaluate durability in demanding road conditions. This tie rod end is a direct service part for steering linkage repair on 2007-2015 Nissan Altima, 2009-2014 Nissan Maxima, 2009-2014 Nissan Murano, and select INFINITI applications including 2013 FX37 and 2014 QX70.

This part cross-references MOOG Chassis Products (e.g., ES800358, ES800511) for the same application.

Common Repair Uses

• Restores steering linkage connection when the outer tie rod end is worn
• Addresses looseness or play in the front steering system
• Helps correct uneven tire wear caused by steering geometry issues
• Supports repair of clunking or knocking from the front suspension area
• Replaces a damaged or corroded tie rod end on Nissan Altima, Maxima, Murano, FX37, or QX70

Installation Notes

Verify the vehicle position before ordering, since TA3008 is listed for front right outer and front left outer applications depending on the vehicle. Confirm thread size, stud type, and overall length against the removed part before installation. A professional alignment is recommended after steering component replacement to restore proper toe settings and steering wheel position.

Quality Assurance

Delphi uses OE-focused testing and material validation for its steering components, including exposure to extreme temperatures and extended salt-spray testing. The TA3008 is built as a standard replacement part with OE-style compatibility checks to support dependable service on the listed Nissan and INFINITI applications.