Delphi TA3045 Steering Tie Rod End - Inner

OE-Style Inner Tie Rod End

The Delphi TA3045 is a steering tie rod end built for the inner position on select Honda and Acura applications. It combines OE-focused dimensional analysis with materials and testing intended to match factory steering feel and fitment.

Compatible with 2006-2011 Honda Civic, inner, and 2006-2011 Acura CSX, inner, this Delphi tie rod end is a direct replacement for worn steering linkage components. The TA3045 is pre-greased, coated, and supplied with mounting hardware for service-ready installation.

Key Features

• Part number: TA3045
• Steering tie rod end for the inner position
• Straight, adjustable design
• Steel housing and steel tie rod construction
• Pre-greased for initial service
• Coated finish with black color
• Male end 1 and male end 2 configuration
• Mounting hardware included
• OE-focused fit and material analysis
• Tested for temperature extremes and salt spray exposure

Detailed Description

Delphi TA3045 is engineered as a standard replacement inner steering tie rod end for vehicles that require precise steering linkage geometry. The straight, adjustable design supports alignment correction during service, while the steel housing and steel tie rod help maintain structural integrity under daily driving loads. Delphi applies OE-style dimensional and material analysis to improve compatibility between the replacement part and the original steering system. The TA3045 also uses a POM bearing material and a coated exterior for added durability in demanding road conditions.

This part cross-references MOOG Chassis Products EV800323 for the same application. For Honda Civic inner tie rod end replacement or Acura CSX steering linkage service, Delphi TA3045 provides a direct-fit option that aligns with OE-style specifications.

Common Repair Symptoms

• Excessive steering play or looseness
• Clunking or knocking from the front steering linkage
• Uneven tire wear caused by worn steering components
• Steering wheel wander or poor tracking
• Alignment that will not hold after adjustment

Installation Notes

• Verify inner-position fitment before installation on Honda Civic and Acura CSX applications.
• Inspect the outer tie rod end, boots, and alignment components during service.
• Set toe alignment after replacement to restore steering geometry.
• Confirm thread direction and thread diameter match the original steering assembly.
• Use the included mounting hardware as required by the application.

Quality Assurance

Delphi subjects steering components to extreme temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. The TA3045 reflects Delphi’s OE-oriented steering portfolio and its focus on dimensional accuracy, material selection, and long-term service consistency.