Delphi TA3057 Steering Tie Rod End - Right Outer

Delphi TA3057 Front Right Outer Tie Rod End

Delphi TA3057 is a standard replacement steering tie rod end for the front right outer position. It is built with OE-focused dimensional and material analysis to help maintain proper steering geometry on supported Nissan and INFINITI applications, including Armada, TITAN, QX56, and QX80 models.

Key Features

• Front right outer steering tie rod end
• Pre-greased design with no grease fitting required
• Dust boot included to help protect the joint
• Steel housing and steel tie rod construction
• Coated black finish for added corrosion resistance
• Clockwise thread direction on both ends
• Mounting hardware included
• Standard replacement part number TA3057

Built for OE-Level Steering Fit

Delphi applies OE safety and engineering experience to its aftermarket steering line, and TA3057 is tested for demanding temperature and corrosion exposure. It is evaluated across extreme cold and heat, along with extended salt spray testing, to help verify durability in real-world steering service. This Delphi TA3057 tie rod end is a direct-fit style replacement for the front right outer steering position on 2004-2015 Nissan TITAN, 2005-2015 Nissan Armada, 2017-2022 Nissan Armada, 2004-2013 INFINITI QX56, 2014-2022 INFINITI QX80, and 2004 Nissan Pathfinder Armada.

This part cross-references MOOG Chassis Products ES800032 and Mevotech Supreme MS30606 for the same application.

What This Part Helps Address

• Loose or imprecise steering feel at the front right wheel
• Uneven tire wear caused by worn steering linkage components
• Clunking or play in the outer tie rod joint
• Steering pull or wandering linked to worn front-end parts
• Failed inspection due to steering component wear

Installation Notes and Tips

Confirm the front right outer position before installation and verify thread direction, thread diameter, and overall dimensions against the original part. After replacement, perform a professional wheel alignment to restore steering geometry and tire wear characteristics. Always inspect the adjacent steering and suspension components for related wear while the system is apart.

Quality Assurance

Delphi validates this steering component with OE-oriented dimensional and material analysis, plus temperature and corrosion testing that includes exposure below -40 degrees C, above 120 degrees C, and 720 hours of salt spray. Those checks support consistent fit and durability across the listed Nissan and INFINITI applications.