Delphi TA3060 Steering Tie Rod End - Inner

OE-Style Inner Tie Rod for Honda Element

Delphi TA3060 is a straight inner steering tie rod end built for precise steering linkage replacement on the 2003-2011 Honda Element. It combines OE-focused dimensional control with corrosion-resistant construction to support consistent steering response and proper alignment.

Fits 2003-2011 Honda Element, inner. Delphi TA3060 is a direct-fit steering tie rod end for drivers replacing worn steering linkage components on the Honda Element.

Key Features

• Inner steering tie rod end for the Honda Element
• Straight design with male-to-male thread configuration
• Adjustable steel construction with coated finish
• Pre-greased for initial service readiness
• Neoprene rubber dust boot helps protect internal components
• Mounting hardware included
• OE-focused dimensional and material analysis for fit consistency
• Tested for temperature extremes and salt-spray exposure

Detailed Description

Delphi TA3060 is a standard replacement inner tie rod end engineered for steering systems that require accurate geometry and dependable articulation. The steel housing and tie rod body are paired with a coated finish to help resist corrosion, while the POM bearing material and neoprene dust boot support smooth movement and protection from road contamination. This part is designed for the 2003-2011 Honda Element and is listed as an inner position component. Delphi TA3060 also cross-references MOOG Chassis Products EV800242 for the same application.

Common Steering Issues It May Solve

• Excessive steering play or looseness at the wheel
• Uneven tire wear caused by worn steering linkage
• Clunking or knocking from the inner steering area
• Steering wander or poor directional stability
• Alignment problems after inspection reveals tie rod wear

Installation Notes and Tips

Confirm the vehicle is a 2003-2011 Honda Element with an inner tie rod application before installation. After replacement, a professional wheel alignment is recommended to restore steering geometry. Inspect the outer tie rod ends, boots, and related steering components at the same time to avoid repeat labor.

Quality Assurance

Delphi applies OE-level engineering practices to its steering portfolio and subjects parts to extreme temperature and salt-spray testing to evaluate durability. The brand also uses dimensional and material analysis to improve OE-to-aftermarket fit consistency.