Delphi TA3063 Steering Tie Rod End - Inner

Delphi TA3063 Front Inner Tie Rod End

Delphi TA3063 is a standard replacement steering tie rod end for front inner applications. It is built with a steel housing and steel tie rod construction, a coated finish, and pre-greased internals for service-ready installation on supported vehicles.

Compatible with 2007-2012 Mazda CX-7 front inner steering and 2002-2010 Lexus SC430 front inner steering, this Delphi tie rod end is engineered for OE-style dimensional and material compatibility. The TA3063 part number is also useful when cross-shopping steering repair parts for Mazda CX-7 and Lexus SC430 front inner service.

Key Features

• Delphi TA3063 steering tie rod end for front inner use
• Standard replacement part with adjustable straight design
• Steel housing and steel tie rod material
• Pre-greased construction with no grease fitting required
• Coated black finish for added surface protection
• Male end connections with clockwise thread direction on both ends
• Mounting hardware included
• Polyoxymethylene (POM) bearing material

Detailed Description

Delphi applies OE-focused engineering to its steering portfolio, and the TA3063 follows that approach with dimensional and material analysis aimed at proper fit and consistent steering service. This front inner tie rod end uses a straight, adjustable design with 14.0 mm thread diameter at both ends, 1.5 thread pitch on the end 2 side, and an overall stud-center length of 184.0 mm (7.244 in). The part is pre-greased, greaseable-free, and does not include a dust boot or grease fitting.

For drivers servicing a Mazda CX-7 or Lexus SC430, Delphi TA3063 provides a direct steering linkage replacement option for front inner wear. This part cross-references MOOG Chassis Products EV800543 for the same application.

What It Helps Address

• Steering play or looseness at the front inner linkage
• Uneven or unstable steering response
• Clunking or knocking from worn steering components
• Alignment issues caused by tie rod wear
• Restoring steering geometry after component replacement

Installation Notes and Tips

Verify thread direction, thread diameter, and overall length before installation. Because this is a front inner steering tie rod end, an alignment should be performed after replacement. Confirm vehicle application by year, make, model, and steering position before ordering.

Quality Assurance

Delphi subjects steering components to extreme temperature and corrosion testing and uses OE-level dimensional and material analysis to support fit and performance consistency. The TA3063 is built as a standard replacement steering part for supported Mazda CX-7 and Lexus SC430 applications.