Delphi TA3066 Steering Tie Rod End - Inner

OE-Style Front Inner Tie Rod End

Delphi TA3066 is a standard replacement steering tie rod end for the front inner position on select Nissan Quest models. Built with OE-focused dimensional and material analysis, it is made to match the original steering geometry and service requirements for 2004-2009 Nissan Quest applications.

For drivers searching for a front inner tie rod end for Nissan Quest, Delphi TA3066 offers a direct-fit steering component with a coated steel housing, steel tie rod construction, and pre-greased assembly. It is also cross-referenced to MOOG Chassis Products EV800227 and Mevotech Supreme MS30717 for the same application.

Key Features

• Fits 2004-2009 Nissan Quest, inner
• Delphi TA3066 steering tie rod end for front inner steering service
• Standard replacement part with OE-based dimensional and material analysis
• Pre-greased design for ready-to-install service
• Steel housing and steel tie rod with coated finish
• Adjustable straight design with male threaded ends
• Mounting hardware included
• No grease fitting and no dust boot included

Detailed Description

Delphi TA3066 is engineered as a front inner steering tie rod end for the 2004-2009 Nissan Quest. The part uses a straight, adjustable design with 16.0 mm threaded ends, clockwise thread direction on both ends, and a 1.5 thread pitch at the outer end. Its steel housing and steel tie rod are paired with a coated finish to support long-term steering service, while the pre-greased construction helps simplify replacement work.

Delphi applies OE-level testing and material validation to its steering portfolio, including exposure to extreme temperature ranges and extended salt-spray testing. That approach helps ensure the TA3066 matches the fit and function expected in Nissan Quest front inner steering repair. If you are replacing a worn Nissan Quest inner tie rod end, Delphi TA3066 provides a direct service part for restoring steering linkage integrity.

Common Problems This Part Can Address

• Excessive steering play in the front inner linkage
• Clunking or looseness from worn steering components
• Uneven tire wear caused by steering geometry wear
• Imprecise steering response during lane changes or turns
• Failed inspection due to worn tie rod end condition

Installation Notes and Tips

Before installation, confirm the vehicle is a 2004-2009 Nissan Quest and verify the front inner steering position. Because this is an adjustable tie rod end, alignment should be checked and set after installation. Inspect the surrounding steering linkage, boots, and related hardware for wear before reassembly. Delphi TA3066 includes mounting hardware, and the pre-greased design reduces prep time during service.

Quality Assurance

Delphi uses OE-focused engineering and validation methods for its steering components, including dimensional and material analysis to support proper fitment and performance. The part is tested under extreme temperature and corrosion conditions to reflect demanding real-world steering use.