Delphi TA3113 Steering Tie Rod End - Outer

Delphi TA3113 Outer Tie Rod End

Delphi TA3113 is a standard replacement steering tie rod end built for the front outer position on select Honda applications. It combines OE-based dimensional and material analysis with corrosion testing and temperature exposure testing to support consistent steering performance in demanding road conditions.

Key Features

• Front outer steering tie rod end for precise linkage replacement
• High-strength steel housing with coated finish
• Dust boot included to help protect the joint from contamination
• Threaded stud design with clockwise thread direction on both ends
• Mounting hardware included
• Standard replacement part number TA3113
• Cross-references MOOG Chassis Products ES800333 for the same application

Detailed Description

Delphi TA3113 is engineered as a steering tie rod end for the outer front steering position. It is built with a high-strength steel housing, steel tie rod material, and a chloroprene rubber dust boot to support durability in everyday driving. Delphi applies OE-focused dimensional and material analysis to help maintain proper compatibility with the original steering geometry on vehicles such as the Honda Odyssey and Honda Ridgeline. This part number, TA3113, is a standard replacement choice for drivers replacing worn steering linkage components on 2011-2017 Honda Odyssey and 2006-2014 Honda Ridgeline outer applications.

Vehicle Fitment

• Fits 2011-2017 Honda Odyssey, outer
• Fits 2006-2014 Honda Ridgeline, outer

Common Problems This Part Can Address

• Loose or vague steering feel from a worn outer tie rod end
• Front-end play or steering wander caused by joint wear
• Clunking or knocking noises from the steering linkage
• Uneven tire wear related to steering component looseness
• Boot damage that allows dirt and moisture into the joint

Installation Notes

Verify the vehicle application, steering position, and thread specifications before installation. TA3113 uses a straight design with female and male threaded ends, so matching the original part dimensions is important for proper alignment setup after replacement. A professional wheel alignment is recommended after steering linkage service.

Quality Assurance

Delphi subjects its steering components to extreme temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. These validation steps support corrosion resistance and long-term performance expectations for OE-style steering service.