Delphi TA3177 Steering Tie Rod End - Right Outer

Delphi TA3177 Right Outer Tie Rod End

Delphi TA3177 is a standard replacement steering tie rod end for the right outer position. It is built with a high-strength steel housing, coated finish, pre-greased construction, and a dust boot to support precise steering response in demanding road conditions.

For Audi A8 Quattro and Audi S8 applications, this Delphi tie rod end is engineered around OE-style dimensions and material analysis for proper fit and steering geometry. The TA3177 is a direct service part for right outer steering repair on select hydraulic steering and variable assist power steering setups.

Key Features

• Right outer steering tie rod end for select Audi applications
• Pre-greased design with no grease fitting required
• Dust boot included to help protect internal components
• High-strength steel housing with coated finish
• Adjustable bent design for steering linkage service
• Threaded stud construction with mounting hardware included
• Standard replacement part number: Delphi TA3177

Detailed Description

Delphi TA3177 is a steering tie rod end designed for the right outer position on 2010-2018 Audi A8 Quattro and 2013-2018 Audi S8 applications listed below. It features a female end 1, male end 2, clockwise thread direction on both ends, and a threaded stud type for serviceability. The part uses a steel tie rod, polyoxymethylene bearing material, and chloroprene rubber dust boot for a durable OE-style steering connection. This part cross-references Beck/Arnley 101-8098 for the same application.

Vehicle Fitment

• Fits 2011-2018 Audi A8 Quattro, right outer
• Fits 2018 Audi S8, right outer
• Fits 2013-2014 Audi S8, right outer
• Fits 2017 Audi S8, right outer; fits vehicles equipped with hydraulic steering
• Fits 2015-2016 Audi S8, right outer; with Variable Assist Power Steering
• Fits 2010 Audi A8 Quattro, right outer; from chassis # 4H-A-000 001 to chassis # 4H-A-010 000

Common Repair Uses

• Restores steering linkage movement at the right outer tie rod position
• Addresses looseness or play in the steering system
• Helps correct uneven tire wear caused by worn steering components
• Replaces a damaged or corroded tie rod end on Audi A8 Quattro or Audi S8
• Supports accurate toe alignment after steering service

Installation Notes and Tips

Verify the right outer position, thread sizes, and chassis notes before installation. After replacement, perform a professional wheel alignment to set toe and confirm steering wheel centering. Delphi TA3177 is pre-greased and does not use a grease fitting, so no additional lubrication point is provided during service.

Quality Assurance

Delphi applies OE-focused dimensional and material analysis to match aftermarket steering parts to original equipment requirements. This tie rod end is tested across extreme temperature ranges and salt-spray exposure to support durability in real-world driving conditions.