Delphi TA3183 Steering Tie Rod End - Right Outer

OE-Style Steering Tie Rod End

Delphi TA3183 is a standard replacement steering tie rod end for the right outer position on select Hyundai Santa Fe and Santa Fe XL applications. Built with OE-focused dimensional and material analysis, it is made to match the steering geometry and fitment requirements of the original part.

This Delphi tie rod end is pre-greased, coated, and supplied with a dust boot and mounting hardware. The bent steel design, threaded stud, and black finish support a direct replacement for worn steering linkage components on Hyundai Santa Fe Sport, Santa Fe, and Santa Fe XL models.

Key Features

• Part number: TA3183
• Right outer steering tie rod end
• Fits 2013-2018 Hyundai Santa Fe, right outer
• Fits 2013-2018 Hyundai Santa Fe Sport, right outer
• Fits 2013-2015 Hyundai Santa Fe XL, right outer
• Fits 2016 Hyundai Santa Fe XL, right outer, to 07/12/2015
• Fits 2017-2019 Hyundai Santa Fe XL, right outer
• Pre-greased and non-greaseable design
• Dust boot included
• Mounting hardware included
• Steel housing and steel tie rod construction
• Coated finish for added surface protection

Detailed Description

Delphi TA3183 is engineered as an OE-style steering tie rod end for the right outer side of the front steering linkage. It uses a steel housing, steel tie rod, plastic bearing material, and a chloroprene rubber dust boot to support consistent steering connection and protection from road contamination. The bent profile, clockwise thread directions, and threaded stud design help maintain the original steering layout on the listed Hyundai vehicles.

Delphi applies OE-level testing and dimensional analysis to its aftermarket steering portfolio, including exposure to extreme temperatures and salt spray conditions. This helps ensure the part aligns with the original fit and material expectations for Hyundai Santa Fe and Santa Fe XL steering service. This part cross-references Beck/Arnley 101-7839 for the same application.

Common Repair Uses

• Restores steering response when the outer tie rod end is worn
• Addresses looseness or play in the right front steering linkage
• Helps correct steering noise caused by joint wear
• Supports proper toe alignment after steering component replacement
• Replaces a damaged dust boot or corroded tie rod end assembly

Installation Notes

Install on the right outer steering position only. Verify thread direction, thread diameter, and overall length before installation to confirm match with the original component. An alignment is required after steering linkage replacement. For 2016 Hyundai Santa Fe XL applications, confirm the vehicle build date is on or before 07/12/2015.

Quality Assurance

Delphi uses OE-focused engineering, dimensional checks, and material validation to support consistent aftermarket steering performance. The part is tested for temperature extremes and salt spray exposure to reflect demanding real-world conditions.