Delphi TA3184 Steering Tie Rod End - Inner

Delphi TA3184 Inner Tie Rod End

Delphi TA3184 is a standard replacement steering tie rod end built for precise inner steering linkage service. It is a straight, adjustable steel component with a coated finish and pre-greased construction for dependable operation in demanding road conditions.

Compatible with select Volvo XC60 applications, this Delphi tie rod end supports accurate steering response and OE-style fitment. Delphi applies dimensional and material analysis to help match aftermarket fit to the original part, and the component is tested for extreme temperature exposure and salt spray resistance.

Key Features

• Part number: TA3184
• Inner steering tie rod end for steering gear and related components
• Straight, adjustable design
• Steel housing and steel tie rod material
• Coated black finish for added corrosion resistance
• Pre-greased; grease fitting not included
• Mounting hardware included
• Male end 1 and male end 2 configuration
• Standard replacement grade

Detailed Description

Delphi TA3184 is engineered as an inner steering tie rod end for Volvo XC60 models listed below. It features an 18.0 mm end 2 thread diameter, 16.0 mm end 1 thread diameter, clockwise thread direction on both ends, and a 1.5 thread pitch at end 2. The unit measures 308.0 mm from stud center to end and uses a steel housing with POM bearing material for controlled movement and durability. This part cross-references MOOG Chassis Products EV800772 for the same application.

Fits 2017 Volvo XC60, inner without Electronic Control Power Steering. Fits 2010-2016 Volvo XC60, inner without Speed Assisted Steering. Delphi TA3184 is a direct-fit steering service part for these XC60 applications and is referenced by technicians looking for a Volvo XC60 inner tie rod end replacement.

Common Repair Uses

• Restores steering linkage precision when the inner tie rod is worn
• Addresses steering play or looseness at the front end
• Helps correct uneven tire wear caused by steering geometry issues
• Replaces a damaged or corroded inner tie rod end
• Supports stable steering feel during lane changes and turns

Installation Notes and Tips

Verify steering system configuration before installation, especially the vehicle note for electronic control power steering or speed assisted steering. Inspect the outer tie rod, boots, and alignment settings during service, and perform a wheel alignment after replacement. Confirm thread direction and thread diameter match the original component before tightening.

Quality Assurance

Delphi uses OE-focused engineering for its aftermarket steering portfolio and subjects parts to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt spray exposure. These validation steps support fit consistency and corrosion resistance for TA3184 in Volvo XC60 steering service.