Delphi TA3190 Steering Tie Rod End - Right Outer

OE-Style Right Outer Tie Rod End

Delphi TA3190 is a steering tie rod end built for the right outer position on select Toyota and Lexus applications. It combines OE-based dimensional analysis with a coated, high-strength steel design to support precise steering response and dependable fitment.

Key Features

• Fits 2011-2017 Lexus CT200h, right outer
• Fits 2010-2015 Toyota Prius, right outer
• Fits 2012-2015 Toyota Prius Plug-In, right outer
• Pre-greased design with dust boot included
• High-strength steel housing with steel tie rod construction
• Coated finish for added corrosion resistance
• Clockwise thread direction on both ends
• Standard replacement grade for OE-style service
• Mounting hardware included

Detailed Description

Delphi TA3190 is a bent steering tie rod end engineered for the right outer steering position. It features a male end, threaded stud design, plastic bearing material, and chloroprene rubber dust boot to support steering joint protection and consistent operation. The part is pre-greased and uses a standard replacement specification for direct service on the listed vehicles. Delphi applies OE-focused dimensional and material analysis to help ensure proper compatibility between the original part and the aftermarket replacement. This part cross-references MOOG Chassis Products ES800841 for the same application.

Common Steering Issues It May Address

• Excessive steering play or looseness at the front end
• Uneven tire wear caused by worn steering linkage components
• Clunking or knocking from the right outer steering area
• Poor steering response or wandering during straight-line driving
• Failed dust boot protection around the tie rod joint

Installation Notes and Tips

Install Delphi TA3190 on the right outer steering position only. After replacement, perform a professional wheel alignment to restore toe settings and steering wheel center. Verify thread direction, stud dimensions, and vehicle application before installation on a 2011-2017 Lexus CT200h, 2010-2015 Toyota Prius, or 2012-2015 Toyota Prius Plug-In. Inspect the adjacent steering components for wear so the new tie rod end is not installed alongside a damaged linkage.

Quality Assurance

Delphi subjects its steering components to extreme temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. These validation steps support OE-level durability expectations for the aftermarket steering portfolio.