Delphi TA3203 Steering Tie Rod End - Inner

OE-Style Inner Tie Rod End for Nissan Juke

Delphi TA3203 is a steering tie rod end built for the inner position on select Nissan Juke models. It combines OE-based dimensional control with a coated steel housing, pre-greased construction, and an adjustable straight design for a precise steering linkage replacement.

• Fits 2011-2017 Nissan Juke, inner
• Delphi TA3203 steering tie rod end for steering system service
• Straight, adjustable design for inner tie rod replacement
• Steel housing and steel tie rod material with coated finish
• Pre-greased construction; grease fitting not included
• Mounting hardware included
• Male end connections with clockwise thread direction
• OE-focused dimensional and material analysis for fit consistency

Built for Steering Precision

This Delphi inner tie rod end is engineered for the steering, gear and related components category and is intended for direct replacement service on the Nissan Juke. Delphi applies OE-level testing and material analysis to help maintain proper compatibility between the original steering geometry and the aftermarket part. The TA3203 is a standard replacement part that uses a steel housing, polyoxymethylene bearing material, and a coated finish for durable service in demanding undercar conditions.

This part cross-references Monroe Shocks & Struts (e.g., D85211KA0A) for the same application.

Common Problems It Can Address

• Excessive steering play from a worn inner tie rod end
• Loose or imprecise steering response
• Uneven front tire wear caused by steering linkage wear
• Clunking or knocking from the steering rack area
• Alignment instability after steering component wear

Installation Notes and Tips

Verify thread direction, thread diameter, and overall length before installation. The TA3203 is an inner tie rod end with male end connections, clockwise thread direction on both ends, and adjustable length for steering linkage setup. After installation, a professional wheel alignment is required to restore correct toe settings and steering wheel position. Confirm vehicle application by year, make, model, and inner position before service.

Quality Assurance

Delphi subjects its steering components to extreme temperature and corrosion testing, including sub-zero and high-heat exposure as well as extended salt-spray testing. The brand also uses dimensional and material analysis to support OE-style fit and performance on applications such as the Nissan Juke. Delphi TA3203 is built as a standard replacement steering tie rod end for consistent service life.