Delphi TA3221 Steering Tie Rod End - Right Outer

OE-Style Steering Tie Rod End for BMW

Delphi TA3221 is a right outer steering tie rod end built for BMW applications that need precise steering linkage replacement. It uses OE-focused dimensional and material analysis to support proper fitment on the listed BMW 2 Series, 3 Series, 4 Series, and M models.

Fits 2017-2020 BMW 230i, right outer; Fits 2017-2020 BMW 430i, right outer; Fits 2016-2020 BMW M2, right outer; Fits 2012-2018 BMW 320i, right outer; Fits 2015-2020 BMW M4, right outer.

• Delphi TA3221 steering tie rod end for right outer steering service
• Pre-greased design with no grease fitting required
• Dust boot included to help protect the joint from contamination
• Coated steel housing and steel tie rod construction
• Male and female threaded ends with clockwise thread direction
• Standard replacement grade for direct steering linkage service
• Mounting hardware included

Detailed Product Overview

This Delphi steering tie rod end is engineered for OE-style replacement on BMW vehicles where steering response and front-end alignment matter. The bent design, threaded stud construction, and specified dimensions help support proper connection at the right outer position. Delphi’s aftermarket steering portfolio is developed from OE expertise, with testing that includes extreme temperature exposure and salt-spray durability evaluation to help verify material performance. This part cross-references Beck/Arnley 101-8002 and MOOG Chassis Products ES801052 for the same application. Delphi TA3221 is a practical replacement choice for BMW 228i, 328i, 335i, 430i, M3, and related models listed in the fitment data.

Common Problems This Part Can Address

• Loose or vague steering feel at the front right wheel
• Clunking or play from a worn outer tie rod end
• Uneven tire wear caused by steering linkage wear
• Steering wheel off-center after suspension or steering wear
• Corrosion-related failure in the steering joint area

Installation Notes and Tips

Verify the vehicle’s right outer application before installation and confirm thread direction, stud type, and dimensions against the removed part. After replacement, a professional wheel alignment is recommended to restore steering geometry and tire wear characteristics. Because this unit is pre-greased and does not use a grease fitting, no routine greasing service is required.

Quality Assurance

Delphi applies OE-focused engineering and durability testing to its steering components, including exposure to temperatures below -40 degrees C and above 120 degrees C, along with extended salt-spray testing. The brand’s dimensional and material analysis is used to improve compatibility between OE and aftermarket fitment for BMW steering service.