Delphi TA3295 Steering Tie Rod End - Right Inner

Delphi TA3295 Right Inner Tie Rod End

Delphi TA3295 is a straight steering tie rod end built as a standard replacement for the right inner position. It is pre-greased, coated, and supplied with mounting hardware, making it a practical OE-style service part for steering repairs on select Honda applications.

Key Features

• Part number: TA3295
• Steering tie rod end for the right inner position
• Straight, adjustable design
• Steel housing and steel tie rod material
• Pre-greased with no grease fitting required
• Coated black finish for added corrosion resistance
• Mounting hardware included
• Bearing material: Polyoxymethylene (POM)
• End 1 thread diameter: 18.0 mm with clockwise thread direction
• End 2 thread diameter: 12.0 mm with clockwise thread direction

Detailed Description

Delphi TA3295 is engineered for steering service where precise inner tie rod replacement is needed. It measures 227.0 mm in overall length and 191.0 mm stud center-to-end, with a 16.0 mm tube diameter and a 35.0 mm width and height profile. The part is pre-greased, non-greaseable, and uses a straight configuration with adjustable length for proper steering linkage setup. Delphi applies dimensional and material analysis to support OE-level fit and function, and the part is tested for extreme temperature and salt-spray exposure to validate durability in demanding conditions.

Fits 2006-2008 Honda Fit, right inner, with 18mm threads. This Delphi TA3295 tie rod end also cross-references Honda 53010SEL003 for the same application.

Common Repair Symptoms

• Steering play or looseness at the wheel
• Uneven tire wear caused by worn steering linkage
• Clunking or knocking from the front steering area
• Improper toe setting that will not hold alignment
• Rough or inconsistent steering response

Installation Notes and Tips

Confirm the right inner position and verify the 18 mm thread specification before installation. After replacement, perform a professional wheel alignment to restore steering geometry. Inspect the adjacent steering components, boots, and fasteners for wear or damage while the system is apart.

Quality Assurance

Delphi uses OE-based engineering, dimensional verification, and material analysis to support fit consistency across aftermarket steering parts. The component is also subjected to temperature and corrosion testing to evaluate performance under harsh operating conditions.