Delphi TA3333 Steering Tie Rod End - Right Outer

OE-Style Front Right Outer Tie Rod End

Delphi TA3333 is a standard replacement steering tie rod end for the front right outer position. It is built with OE-focused dimensional and material analysis to support proper steering geometry and consistent fit on select Chevrolet and Buick applications, including the Malibu, LaCrosse, Regal Sportback, and Regal TourX.

Key Features

• Front right outer steering tie rod end
• Fits 2016-2022 Chevrolet Malibu, right outer
• Fits 2017-2019 Buick LaCrosse, right outer
• Fits 2018-2020 Buick Regal Sportback, right outer
• Fits 2018-2020 Buick Regal TourX, right outer
• Pre-greased design with no grease fitting
• Dust boot included for added joint protection
• Coated steel housing and steel tie rod construction
• Bent style with threaded stud design
• Mounting hardware included

Detailed Description

Delphi TA3333 is engineered as a standard replacement steering tie rod end for the front right outer steering position. It features a black coated finish, steel housing, steel tie rod material, and a chloroprene rubber dust boot. The joint is pre-greased, non-greaseable, and uses a threaded stud with clockwise thread direction on both ends. Delphi validates its steering components through temperature and corrosion exposure testing, including sub-zero and high-heat conditions plus extended salt spray testing, to help maintain OE-level dimensional consistency and material performance. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. Delphi TA3333 is a direct-fit steering service part for Chevrolet Malibu and Buick Regal/LaCrosse front-end repair work where precise outer tie rod replacement is required.

What This Part Helps Address

• Loose or wandering steering feel
• Front-end toe misalignment
• Clunking or play from the outer steering linkage
• Uneven tire wear caused by worn steering joints
• Steering response issues at the front right wheel

Installation Notes and Tips

Verify the front right outer position before installation and confirm thread direction, thread diameter, and overall dimensions against the removed part. After replacement, perform a professional wheel alignment to restore steering geometry. Inspect the adjacent steering and suspension components for wear while the system is apart.

Quality Assurance

Delphi applies OE-based engineering and validation to its aftermarket steering portfolio. TA3333 is tested for dimensional accuracy, material compatibility, temperature extremes, and corrosion resistance to support dependable replacement performance on the listed Chevrolet and Buick vehicles.