Delphi TA3360 Steering Tie Rod End - Inner

Delphi TA3360 Inner Steering Tie Rod End

Delphi TA3360 is an inner steering tie rod end built for OE-style steering performance and direct replacement service. It is engineered for the 2018-2021 GMC Terrain, 2017-2020 Buick Envision, and 2018-2020 Chevrolet Equinox, with fitment focused on the inner steering position.

Key Features

• Inner steering tie rod end for steering linkage service
• Fits 2018-2021 GMC Terrain, inner
• Fits 2017-2020 Buick Envision, inner
• Fits 2018-2020 Chevrolet Equinox, inner
• Adjustable straight design with male-to-male ends
• Pre-greased for installation readiness
• Steel housing and steel tie rod construction
• Coated black finish for added corrosion resistance
• Mounting hardware included
• OE-focused dimensional and material analysis for application match

Detailed Description

Delphi TA3360 is designed as an inner steering tie rod end for vehicles that require precise steering linkage geometry. It features a straight, adjustable layout with 16.0 mm and 14.0 mm thread diameters, 1.5 thread pitch, clockwise thread direction on both ends, and a steel housing with a coated finish. The part is pre-greased and uses Polyoxymethilen (POM) bearing material for consistent movement in steering service. This part cross-references Mevotech Supreme MS50789 for the same application.

Built with Delphi’s OE-focused steering expertise, TA3360 is tested for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray during validation. That level of testing supports dependable performance in demanding road and weather conditions. For shoppers searching for a Delphi TA3360 inner tie rod end for GMC Terrain, Buick Envision, or Chevrolet Equinox steering repair, this part provides a direct-fit service option.

Common Steering Issues It May Address

• Excessive steering play or looseness at the inner tie rod
• Clunking or knocking from the steering linkage
• Uneven tire wear caused by worn steering components
• Imprecise steering response during lane changes or turns
• Steering vibration traced to worn inner linkage joints

Installation Notes and Tips

Confirm the inner steering position and verify thread direction, thread diameter, and overall length before installation. Because this is an adjustable steering component, alignment should be checked after replacement. Inspect related steering parts, including outer tie rod ends and boots, during service to help ensure the steering system is restored correctly.

Quality Assurance

Delphi applies OE dimensional and material analysis to match aftermarket steering parts to original equipment requirements. TA3360 is validated through temperature cycling and salt-spray exposure testing to support durability in real-world use.