Delphi TA3368 Steering Tie Rod End - Inner

Delphi TA3368 Inner Tie Rod End

The Delphi TA3368 is an inner steering tie rod end built for precise steering linkage service on select Mitsubishi Mirage and Mirage G4 models. It uses a straight, adjustable steel design with a coated finish and pre-greased construction for dependable replacement of worn steering components.

Key Features

• Inner steering tie rod end for steering gear and related components
• Fits 2014-2022 Mitsubishi Mirage, inner
• Fits 2017-2022 Mitsubishi Mirage G4, inner
• Steel housing and steel tie rod construction
• Pre-greased design with no grease fitting required
• Adjustable straight style for steering linkage alignment
• Coated black finish for added surface protection
• Mounting hardware included
• End 1 thread: 14.0 mm, clockwise, 1.5 pitch
• End 2 thread: 12.0 mm, clockwise, 1.25 pitch

Detailed Description

Delphi applies OE-focused dimensional and material analysis to its steering portfolio so the replacement part matches the original application as closely as possible. The TA3368 is engineered for inner steering service on the Mitsubishi Mirage and Mitsubishi Mirage G4, with a steel body, polyoxymethylene bearing material, and pre-lubricated construction to support consistent steering response. Delphi tests steering components under extreme temperature and corrosion conditions, including sub-zero and high-heat exposure and extended salt spray testing, to validate durability in demanding environments. This part cross-references MOOG Chassis Products EV801372 for the same application.

Common Problems This Part Can Address

• Excessive steering play from a worn inner tie rod end
• Clunking or looseness in the steering linkage
• Uneven tire wear caused by steering geometry wear
• Steering wander or poor on-center feel
• Failed replacement of a damaged steering tie rod end on Mirage or Mirage G4 models

Installation Notes and Tips

Install the Delphi TA3368 on the inner steering position only. Verify thread direction, thread pitch, and overall length before installation to confirm proper steering rack fitment on the vehicle. After replacement, perform a professional wheel alignment to restore steering geometry and tire wear characteristics. For fitment confirmation, use the vehicle application data for 2014-2022 Mitsubishi Mirage and 2017-2022 Mitsubishi Mirage G4, inner.

Quality Assurance

Delphi backs its steering components with OE-level engineering practices, including dimensional checks and material validation for aftermarket use. The part is tested for temperature extremes and corrosion resistance to support long-term service in steering applications. Part number TA3368 identifies this inner tie rod end for ordering and fitment verification.