Delphi TA3380 Steering Tie Rod End - Front Left Outer

Delphi Steering Tie Rod End TA3380

Delphi TA3380 is a front left outer steering tie rod end built for the 2016-2021 Honda HR-V. It is a standard replacement part with a bent design, pre-greased construction, and a rubber dust boot to help protect the joint in daily driving conditions.

Key Features

• Fits 2016-2021 Honda HR-V, front left outer
• Delphi part number TA3380
• Steel housing and steel tie rod material
• Pre-greased with dust boot included
• Bent, non-adjustable design
• Threaded stud with clockwise thread direction on both ends
• Mounting hardware included
• Standard replacement grade

Detailed Product Overview

This Delphi steering tie rod end is engineered for the front left outer position on the Honda HR-V and is built to match OE-style dimensions and material requirements. Delphi applies dimensional and material analysis to improve fitment consistency between the original part and the aftermarket replacement, while its steering components are tested across extreme temperature and corrosion conditions. If you are replacing a worn outer tie rod end on a 2016, 2017, 2018, 2019, 2020, or 2021 Honda HR-V, TA3380 provides a direct-service replacement for the steering linkage.

This part cross-references MOOG Chassis Products ES801389 for the same application.

Common Problems This Part Can Address

• Loose or vague steering feel at the front left wheel
• Clunking or knocking from the steering linkage
• Uneven tire wear caused by worn tie rod end joints
• Excess play in the outer steering connection
• Failed dust boot or contaminated joint wear

Installation Notes and Tips

Install TA3380 at the front left outer steering position only. After replacement, a professional wheel alignment is recommended to restore steering geometry and tire wear characteristics. Verify thread direction, stud dimensions, and vehicle-side fitment before installation on the Honda HR-V.

Quality Assurance

Delphi uses OE-focused engineering and validation for its steering portfolio, including temperature exposure below -40 degrees C and above 120 degrees C, plus extended salt-spray testing for corrosion resistance. The brand also performs dimensional and material analysis to support consistent OE-to-aftermarket compatibility.