Delphi TA3391 Steering Tie Rod End - Front Left Outer

Delphi TA3391 Front Left Outer Tie Rod End

Delphi TA3391 is a standard replacement steering tie rod end for the front left outer position. It is built with a steel housing, pre-greased construction, and a rubber dust boot to support consistent steering response in everyday driving.

Key Features

• Part number: TA3391
• Steering tie rod end for front left outer applications
• Adjustable, straight design
• Steel housing with black finish
• Pre-greased; grease fitting not included
• Dust boot included with rubber boot material
• Mounting hardware included
• Clockwise (right) thread direction on both ends
• Threaded stud design with female and male end configuration

Fitment

• Fits 2014-2020 Fiat 500L, Front Left Outer
• Fits 2016-2020 Fiat 500X, Front Left Outer
• Fits 2017-2020 Jeep Compass, Front Left Outer
• Fits 2015-2018 Jeep Renegade, Front Left Outer

Detailed Description

Delphi applies OE-focused steering expertise to the TA3391 tie rod end, using dimensional and material analysis to help maintain proper fit and steering geometry. The part is engineered for the front left outer location on select Fiat and Jeep models, including the Fiat 500L, Fiat 500X, Jeep Compass, and Jeep Renegade. Delphi TA3391 is a practical OE-style replacement for drivers addressing worn steering linkage components on these vehicles.

This part cross-references MOOG Chassis Products ES801215 for the same application.

What It Helps Address

• Steering play or looseness at the front left outer tie rod end
• Clunking or knocking from worn steering linkage components
• Uneven tire wear caused by steering alignment issues
• Imprecise steering feel during lane changes and turns
• Visible boot wear or contamination at the outer tie rod end

Installation Notes and Tips

Confirm the front left outer position before installation and inspect the mating steering components for wear. Because this is an adjustable tie rod end, alignment should be checked after installation to restore correct toe settings. Verify thread direction and stud dimensions against the removed part before assembly.

Quality Assurance

Delphi tests steering components for temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure. The TA3391 also reflects Delphi’s OE-level dimensional and material review for fit consistency in aftermarket service.