Delphi TA3583 Steering Tie Rod End - Inner

Delphi Inner Tie Rod End for Sorento

Delphi TA3583 is a straight inner steering tie rod end built for precise steering linkage replacement on select Kia Sorento models. It uses a steel housing and steel tie rod construction, with a pre-greased design and included mounting hardware for service-ready installation.

Fits 2016-2019 Kia Sorento, inner. This Delphi TA3583 tie rod end is engineered for the steering system on the Sorento and is a direct-fit replacement for the listed application.

Key Features

• Part number: TA3583
• Inner steering tie rod end
• Straight design with adjustable fitment
• Steel housing and steel tie rod material
• Pre-greased for initial service use
• Male threaded ends with clockwise thread direction
• Mounting hardware included
• Black finish
• Standard replacement grade

Detailed Description

Delphi applies OE-focused steering expertise to this aftermarket tie rod end, using dimensional and material analysis to support proper fit and function. The TA3583 is built for the inner steering position and is specified for 2016-2019 Kia Sorento models. It measures 270.10 mm in overall length and uses a threaded stud design with a 231.60 mm stud-center-to-end length. Delphi also validates steering components through extreme temperature exposure below -40 degrees C and above 120 degrees C, along with extended salt spray testing for corrosion resistance evaluation.

This part cross-references MOOG Chassis Products EV801491 for the same application.

Common Problems This Part Can Address

• Excessive steering play from a worn inner tie rod end
• Clunking or looseness in the steering linkage
• Uneven tire wear caused by steering component wear
• Imprecise steering response during lane changes or turns
• Failed inspection due to steering system wear

Installation Notes and Tips

Replace the inner tie rod end during a front-end steering inspection and verify alignment after installation. Because this Delphi TA3583 is adjustable, final toe settings should be checked and corrected to factory specification. Confirm the vehicle is a 2016-2019 Kia Sorento with inner steering application before installation.

Quality Assurance

Delphi builds this steering component using OE-oriented design and validation methods, including dimensional and material analysis plus environmental testing for temperature and corrosion exposure. The result is a standard replacement part intended to match the listed Sorento application with consistent steering-system fitment.