Delphi TA3592 Steering Tie Rod End - Front Inner

Front Inner Tie Rod End for Honda Odyssey

Delphi TA3592 is a straight steering tie rod end for the front inner position on select Honda Odyssey models. It is built as a standard replacement with a steel housing and steel tie rod material, and it comes pre-greased with mounting hardware included.

Compatible with 2018-2025 Honda Odyssey front inner steering applications, this Delphi tie rod end is engineered using OE-focused dimensional and material analysis for proper fit and steering system consistency. The TA3592 part number is also a useful reference when comparing replacement options for the Honda Odyssey front inner tie rod end.

Key Features

• Part number: TA3592
• Steering tie rod end for front inner position
• Straight design with male ends
• Pre-greased for service-ready installation
• Steel housing and steel tie rod construction
• Standard replacement grade
• Mounting hardware included
• Counterclockwise (left) thread direction on both ends
• Not adjustable and not greaseable

Detailed Description

Delphi TA3592 is a front inner steering tie rod end made for 2018-2025 Honda Odyssey models. The design uses a straight, male-end configuration with threaded studs and a steel housing to match the demands of steering linkage service. Delphi applies OE dimensional and material analysis to help ensure the replacement part aligns with the original steering geometry and installation requirements. The TA3592 part number is also cross-referenced in the aftermarket for the same application.

This part cross-references Honda 53610-THR-A01 for the same application.

What It Helps Address

• Excessive steering play at the front inner linkage
• Clunking or looseness from worn steering components
• Uneven steering response caused by worn tie rod hardware
• Front-end alignment issues related to steering linkage wear
• Replacement needs during steering system repair on a Honda Odyssey

Installation Notes and Tips

Fits 2018-2025 Honda Odyssey, front inner. Verify thread direction, position, and overall length before installation. Because this is a non-adjustable tie rod end, confirm the steering linkage setup matches the original part before service. A professional alignment should be performed after steering component replacement.

Quality Assurance

Delphi subjects steering components to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to evaluate durability in demanding conditions. The TA3592 part number reflects Delphi’s OE-focused aftermarket steering portfolio for the Honda Odyssey front inner application.