Delphi TA3614 Steering Tie Rod End - Left Outer

Delphi TA3614 Left Outer Tie Rod End

Delphi TA3614 is a steering tie rod end built for the left outer position on select Ford Ranger applications. It combines OE-based dimensional analysis with materials and testing that support consistent steering response, secure fitment, and dependable service in demanding conditions.

Key Features

• Fits 2019-2022 Ford Ranger, left outer
• Delphi TA3614 steering tie rod end for standard replacement service
• Pre-greased design with dust boot included
• Steel housing and steel tie rod construction with painted finish
• Bent style, threaded stud design, clockwise (right) thread direction on both ends
• Mounting hardware included
• Black boot and black housing for OE-style appearance
• Cross-references Mevotech Supreme MS406112 for the same application

Detailed Description

Delphi TA3614 is engineered as a standard replacement steering tie rod end for the left outer position on the Ford Ranger. It measures 221.50 mm in overall length, uses a 0.488 in / 12.40 mm stud and cone outside diameter, and features a 21.00 mm tube diameter with a steel housing and chloroprene rubber dust boot. The pre-greased, non-greaseable design helps simplify service, while the included dust boot and mounting hardware support a complete replacement job. Delphi applies OE-focused dimensional and material analysis to help maintain proper compatibility between the original steering geometry and the replacement part. This part number, TA3614, is also referenced in interchange listings for related aftermarket applications.

Common Repair Uses

• Restores steering linkage integrity when the outer tie rod end is worn
• Addresses looseness or play at the front steering connection
• Helps correct uneven tire wear caused by steering component wear
• Supports accurate toe adjustment after front-end service
• Replaces a damaged or corroded left outer tie rod end on Ford Ranger trucks

Installation Notes and Tips

Fits 2019-2022 Ford Ranger, left outer. Confirm the steering side and position before installation, and inspect the mating components, including the inner tie rod and alignment settings, during service. Because this part is non-adjustable and uses a threaded stud design, final alignment should be checked after installation. Delphi TA3614 is intended for direct replacement use on the listed Ford Ranger fitment.

Quality Assurance

Delphi subjects its steering components to OE-style validation, including extreme temperature exposure below -40 degrees C and above 120 degrees C, plus 720 hours of salt spray testing. That testing, along with dimensional and material analysis, supports consistent fit and durability for the TA3614 tie rod end.