Delphi TA3690 Steering Tie Rod End - Front Inner

Delphi TA3690 Front Inner Tie Rod End

Delphi TA3690 is a standard replacement steering tie rod end built for the front inner position on select Jeep Cherokee models. It combines a straight steel body, pre-greased construction, and adjustable fitment to support precise steering response in everyday driving.

Compatible With 2019-2023 Jeep Cherokee, front inner. Delphi applies OE-focused dimensional and material analysis to help match aftermarket fitment to the original steering layout.

Key Features

• Part number TA3690 for front inner steering service
• Fits 2019-2023 Jeep Cherokee, front inner
• Straight, adjustable tie rod end design
• Steel tie rod material with painted black finish
• Pre-greased for initial installation
• Male end configuration with threaded stud
• Power steering application
• Mounting hardware included

Detailed Description

Delphi TA3690 is engineered as a standard replacement steering tie rod end for the front inner position. It measures 13.110 in. (333.00 mm) in length and uses a 0.709 in. (18.00 mm) tube diameter with a 0.630 in. (16.00 mm) stud length. The unit is adjustable, straight, and finished in painted black steel for a durable service replacement.

Delphi subjects its steering components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt spray testing. That OE-based validation, along with dimensional and material analysis, supports accurate replacement on Jeep Cherokee steering systems. This part cross-references MOOG Chassis Products EV801522 for the same application.

What This Part Helps Address

• Loose or vague steering feel at the front inner linkage
• Uneven steering response caused by worn tie rod end joints
• Clunking or play in the steering system
• Front-end alignment issues related to steering linkage wear
• Replacement needs after corrosion or joint fatigue

Installation Notes and Tips

Install TA3690 at the front inner steering location only on confirmed Jeep Cherokee applications. Verify thread direction, overall length, and steering linkage condition before alignment. Because this is a pre-greased, non-greaseable design, service intervals are handled through replacement rather than lubrication. Mounting hardware is included; cotter pin, washer, dust boot, and locking nut are not included.

Quality Assurance

Delphi builds this steering tie rod end using OE-focused engineering and validation methods used across its aftermarket steering portfolio. The part is tested for temperature extremes and salt exposure to help maintain performance in demanding road conditions.