Delphi TA3717 Steering Tie Rod End - Inner

Delphi TA3717 Inner Tie Rod End for Mazda 3

Delphi TA3717 is a straight inner steering tie rod end built for power steering systems and direct replacement service. It is listed for 2019-2023 Mazda 3 inner applications and uses OE-focused dimensional and material analysis to support proper fit and steering response.

Key Features

• Fits 2019-2023 Mazda 3, inner
• Part number: TA3717
• Straight tie rod end with clockwise (right) thread direction
• Standard replacement grade with steel housing and steel tie rod material
• Pre-greased design for ready-to-install service
• Adjustable construction with locking nut included
• Power steering application
• Black painted finish

Detailed Description

Delphi TA3717 is an inner steering tie rod end engineered for the Mazda 3 platform from 2019 through 2023. It is a male-to-male, straight design with a threaded stud and hex head drive type, and it is specified with clockwise thread direction on both ends. The unit measures 250.50 mm in overall length, with a 16.00 mm tube diameter and a 16.00 mm stud length listed in the product data.

Built with a steel housing and steel tie rod material, this Delphi steering component is pre-greased and finished in painted black. It is not greaseable, and it does not include a dust boot, grease fitting, cotter pin, castle nut, washer, or mounting hardware. Delphi’s OE-based testing and dimensional analysis help maintain consistency between the original part and the aftermarket replacement.

This part cross-references MOOG Chassis Products EV801633 for the same application.

What It Helps Address

• Inner tie rod wear that can contribute to steering play
• Loose or imprecise steering feel in a Mazda 3
• Clunking or knocking from the steering linkage
• Uneven toe settings caused by worn steering components
• Restoration of steering response after front-end service

Installation Notes and Tips

Fits 2019-2023 Mazda 3, inner. Confirm right-hand thread orientation before installation and verify alignment after replacement. Because this is an adjustable steering component, final toe settings should be checked and corrected after installation. Inspect the adjoining steering linkage and related wear points before completing the repair.

Quality Assurance

Delphi applies OE-focused testing to its steering portfolio, including exposure to extreme temperatures below -40 degrees C and above 120 degrees C, plus extended salt-spray testing for corrosion resistance. The brand also uses dimensional and material analysis to support OE-to-aftermarket consistency for the TA3717 inner tie rod end.