Delphi TA3851 Steering Tie Rod End - Front Right Outer

Front Right Outer Tie Rod End for VW and Audi

Delphi TA3851 is a front right outer steering tie rod end built for vehicles that need precise steering response and OE-style fit. It is a direct replacement for select Audi Q3 and Volkswagen models, including Tiguan, Jetta, Passat, and Beetle applications.

Key Features

• Front right outer steering tie rod end
• OE-focused dimensional and material analysis for fit consistency
• Tested for temperature extremes below -40 C and above 120 C
• Exposed to 720 hours of salt spray during validation
• Designed for select Audi Q3 and Volkswagen steering applications
• Part number TA3851 for catalog matching and cross-reference lookup

Detailed Description

Delphi applies OE engineering knowledge to its aftermarket steering portfolio, and TA3851 reflects that approach with attention to fit, material selection, and durability. This front right outer tie rod end is listed for 2015-2025 Audi Q3, 2009-2023 Volkswagen Tiguan, 2011-2018 Volkswagen Jetta, 2006-2010 Volkswagen Passat, and additional Volkswagen applications such as Arteon, Golf, GTI, Beetle, e-Golf, Golf Alltrack, Golf SportWagen, Tiguan Limited, and Passat CC. If you are searching for a front right outer tie rod end for a Volkswagen Tiguan or Audi Q3, TA3851 is a direct catalog match.

This part cross-references MOOG Chassis Products ES80667 and Dorman - OE Solutions 534-918 for the same application.

What It Helps Address

• Loose or vague steering feel at the front right corner
• Uneven tire wear caused by worn steering linkage components
• Steering play or clunking from a deteriorated outer tie rod end
• Alignment instability after suspension or steering wear
• Restoration of steering response on compatible Audi and Volkswagen models

Installation Notes and Tips

Verify the vehicle’s year, make, model, and front right outer position before ordering. After installation, a professional wheel alignment is recommended to confirm steering geometry and tire wear settings. Always compare the removed part to the new component for thread, length, and end style match before assembly.

Quality Assurance

Delphi validates steering components through extreme-temperature testing and extended corrosion exposure, along with dimensional and material analysis to support OE-style compatibility. That testing focus helps ensure TA3851 meets the demands of daily driving in a wide range of conditions.