Delphi TA5006 Steering Tie Rod End - Right Outer

Delphi TA5006 Right Outer Tie Rod End

Delphi TA5006 is a standard replacement steering tie rod end for the right outer position. It is built with OE-focused dimensional and material analysis to support proper fit on select Honda and Acura applications, including the Honda Pilot, Acura MDX, and Acura ZDX.

Key Features

• Right outer steering tie rod end for select vehicles
• Pre-greased design with no grease fitting
• Dust boot included to help protect the joint
• Steel housing and steel tie rod construction
• Coated black finish for added surface protection
• Bent design with threaded stud connection
• Mounting hardware included
• Clockwise thread direction on both ends

Product Details

The Delphi TA5006 steering tie rod end is engineered for OE-style replacement performance in the steering linkage. Delphi subjects its steering components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and 720 hours of salt spray, to evaluate durability under demanding conditions. This part number is a direct-fit option for 2009-2015 Honda Pilot right outer steering service, 2007-2013 Acura MDX right outer steering repair, and 2010-2013 Acura ZDX right outer steering replacement. Delphi TA5006 also cross-references Beck/Arnley 101-7670 for the same application.

Common Issues This Part Can Address

• Steering play or looseness at the right outer tie rod end
• Uneven tire wear caused by worn steering linkage components
• Clunking or knocking from the front steering area
• Imprecise steering response during lane changes or turns
• Visible wear, torn boot, or corrosion at the tie rod end

Installation Notes and Tips

Verify the vehicle’s right outer steering position before installation and confirm thread direction, thread diameter, and overall dimensions against the removed part. After replacing the tie rod end, a professional wheel alignment is required to restore steering geometry. This Delphi TA5006 tie rod end is pre-greased and does not use a grease fitting, so no routine greasing is needed after installation.

Quality Assurance

Delphi applies OE-level dimensional and material analysis to help match aftermarket fitment to original equipment requirements. The part is tested for temperature extremes and salt-spray exposure to evaluate performance and corrosion resistance in real-world steering service.