Delphi TA5011 Steering Tie Rod End - Outer

Delphi TA5011 Outer Tie Rod End

Delphi TA5011 is a standard replacement steering tie rod end built for outer steering linkage service on select BMW and Porsche applications. It uses OE-based dimensional and material analysis to support proper fitment, with pre-greased construction, a coated steel housing, and a dust boot for added protection.

Key Features

• Outer steering tie rod end for select BMW 320i and Porsche 911 applications
• Pre-greased design with no grease fitting required
• Steel housing with coated finish for corrosion resistance
• Dust boot included to help protect internal components
• Adjustable straight design with threaded male and female ends
• Mounting hardware included
• Delphi TA5011 is engineered using OE dimensional and material analysis

Detailed Description

The Delphi TA5011 steering tie rod end is a standard replacement part for the outer position on select 1976-1983 BMW 320i and 1976-1977 Porsche 911 models. It features a straight, adjustable design with clockwise thread direction on both ends, a threaded stud, and a steel tie rod body. The pre-greased assembly includes a dust boot made from chloroprene rubber and a POM bearing material to support smooth steering linkage operation. Delphi validates its steering components through extreme temperature exposure and salt-spray testing to help confirm durability in demanding road conditions. This part cross-references Beck/Arnley 101-3401 for the same application.

What It Helps Address

• Steering looseness at the outer tie rod connection
• Excessive play or wandering in the front end
• Uneven tire wear caused by worn steering linkage components
• Noisy or unstable steering response during turning
• Replacement needs for worn outer tie rod ends on BMW 320i and Porsche 911

Installation Notes and Tips

Install Delphi TA5011 at the outer steering position only. Verify thread size, thread direction, and overall length before installation, and inspect the mating steering components for wear. After replacement, a professional wheel alignment is recommended to restore correct steering geometry. For fitment, this part fits 1977-1983 BMW 320i, outer, and fits 1976-1977 Porsche 911, outer. Delphi TA5011 is also listed for 1976-1983 BMW 320i and 1976-1977 Porsche 911 outer applications in expanded fitment data.

Quality Assurance

Delphi applies OE-focused engineering to its aftermarket steering portfolio and subjects parts to temperature extremes below -40 degrees C and above 120 degrees C, along with 720 hours of salt-spray exposure. These validation steps support consistent material performance and fit accuracy for the Delphi TA5011.