Delphi TA5025 Steering Tie Rod End - Inner

OE-Style Inner Tie Rod End for Nissan Altima

Restore precise steering response with this Delphi inner steering tie rod end, part number TA5025. It is a straight, adjustable replacement built with a steel housing and steel tie rod, pre-greased for service-ready installation on select 1998-2001 Nissan Altima models.

Delphi applies OE-level dimensional and material analysis to its steering portfolio, helping the aftermarket part match the original application more closely. This Delphi TA5025 inner tie rod end is engineered for consistent fitment on the Nissan Altima steering system.

• Fits 1998-2001 Nissan Altima, inner
• Delphi TA5025 steering tie rod end
• Inner position replacement for steering linkage service
• Straight, adjustable design
• Steel housing and steel tie rod construction
• Pre-greased; grease fitting not included
• Black coated finish for added surface protection
• Male/male end configuration with clockwise thread direction

Detailed Product Overview

The Delphi TA5025 is a standard replacement inner tie rod end designed for steering systems that require accurate linkage movement and stable alignment adjustment. It features a 14.0 mm end 1 thread diameter and a 12.0 mm end 2 thread diameter, with 1.5 mm and 1.25 mm thread pitches respectively. The unit measures 311.5 mm in overall length and uses a polyoxymethylene (POM) bearing material for controlled movement at the joint. For shoppers searching for a 1998-2001 Nissan Altima inner tie rod end or Delphi TA5025, this part provides a direct-service steering solution.

This part cross-references Beck/Arnley (e.g., 101-4838) and QuickSteer (e.g., EV401) for the same application.

Common Steering Issues It May Address

• Excessive steering play or looseness in the inner linkage
• Uneven toe settings caused by worn steering components
• Clunking or knocking from the steering rack area
• Imprecise steering feel during lane changes or turns
• Wear-related replacement needs on a 1998-2001 Nissan Altima

Installation Notes and Tips

Verify thread direction, thread diameter, and overall length against the original part before installation. Because this is an inner tie rod end, alignment should be checked and adjusted after replacement to confirm proper steering geometry. Inspect related steering components for wear at the same time, especially if the vehicle has high mileage or uneven tire wear.

Quality Assurance

Delphi tests steering components across extreme temperature and corrosion conditions, including sub-zero and high-heat exposure and extended salt-spray testing. That OE-focused validation supports consistent performance and fit for the Delphi TA5025 on select Nissan Altima applications.