Delphi TA5037 Steering Tie Rod End - Right Outer

Delphi TA5037 Right Outer Tie Rod End

Delphi TA5037 is a standard replacement steering tie rod end for the right outer position on select Kia Sportage models. Built with OE-focused dimensional and material analysis, it is made to match the steering geometry and fitment requirements of the original application.

For 1995-2002 Kia Sportage right outer steering service, this Delphi tie rod end combines a steel housing and steel tie rod with a coated black finish, pre-greased construction, and a dust boot included for added protection.

Key Features

• Part number: TA5037
• Fits 1995-2002 Kia Sportage, right outer
• Standard replacement steering tie rod end
• Pre-greased design with no grease fitting
• Dust boot included with chloroprene rubber material
• Steel housing and steel tie rod construction
• Clockwise thread direction at both ends
• Mounting hardware included
• Black coated finish

Detailed Description

Delphi TA5037 is engineered for the right outer steering position on Kia Sportage models from 1995 through 2002. The bent design, female end configuration, and threaded stud layout support proper steering linkage connection, while the 16 mm cone outside diameter and 18 mm end 2 thread diameter help maintain OE-style dimensional match. Delphi applies extensive material and dimensional analysis to improve compatibility between the original steering setup and the aftermarket replacement. The part number TA5037 is also referenced in cross applications such as ES3485 and ES3486.

What This Part Helps Address

• Loose or worn steering feel at the right outer tie rod location
• Excessive play in the steering linkage
• Uneven front tire wear caused by steering end wear
• Clunking or knocking from the front steering assembly
• Restoring proper toe adjustment retention after tie rod wear

Installation Notes and Tips

Verify right outer fitment before installation on 1995-2002 Kia Sportage models. Match the thread direction, thread diameters, and stud configuration to the original part before alignment. Because this steering component affects wheel alignment, a professional alignment should be performed after replacement. Confirm the steering knuckle and tie rod connection surfaces are clean and free of damage before assembly.

Quality Assurance

Delphi subjects its steering components to extreme temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt spray testing. That validation supports OE-style durability for everyday steering service on the Kia Sportage. Part number TA5037 reflects Delphi’s aftermarket steering expertise for this application.