Delphi TA5097 Steering Tie Rod End - Outer

OE-Style Outer Tie Rod End for Infiniti G20

Delphi TA5097 is a steering tie rod end built for outer steering linkage service on select Infiniti G20 applications. It combines OE-based dimensional analysis with materials chosen for durability, helping restore precise steering response and stable front-end alignment.

Fits 1991-1996 Infiniti G20, outer. Fits 1999-2002 Infiniti G20, outer. This part cross-references Beck/Arnley 101-5412 for the same application.

Key Features

• Part number TA5097
• Outer steering tie rod end for Infiniti G20 applications
• Pre-greased design with dust boot included
• Steel housing and steel tie rod construction
• Coated black finish for added corrosion resistance
• Threaded stud design with clockwise thread direction on both ends
• Standard replacement grade
• Mounting hardware included

Detailed Description

Delphi TA5097 is engineered as a standard replacement steering tie rod end for the outer position on select Infiniti G20 models. Delphi applies OE-focused dimensional and material analysis to help ensure proper fitment and consistent steering geometry. The component is tested across extreme temperature ranges and salt-spray exposure to reflect demanding undercar conditions, while the pre-greased, sealed design supports long-term serviceability.

Built with a steel housing, steel tie rod material, and a chloroprene rubber dust boot, this outer tie rod end is made for direct steering linkage replacement on 1991-1996 and 1999-2002 Infiniti G20 vehicles. If you are searching for a Delphi TA5097 outer tie rod end for Infiniti G20 steering repair, this part matches the listed applications and supports accurate front-end restoration.

Common Problems This Part Can Address

• Loose or wandering steering feel
• Front-end play caused by worn outer tie rod joints
• Uneven tire wear from steering linkage wear
• Clunking or knocking from the front suspension area
• Steering response that no longer tracks accurately

Installation Notes and Tips

• Verify outer position fitment before installation.
• Inspect the inner tie rod, boots, and alignment components at the same time.
• Set toe alignment after replacement to protect tire wear and steering feel.
• Confirm thread direction and thread pitch match the vehicle side and steering linkage.
• Check all fasteners and cotter-style retention points during final assembly.

Quality Assurance

Delphi uses OE-oriented testing and material validation for its steering portfolio, including exposure to extreme temperatures and extended salt-spray testing. The TA5097 is built to support consistent fit and durability in everyday steering service on Infiniti G20 applications.