Delphi TA5098 Steering Tie Rod End - Right Outer

Delphi TA5098 Right Outer Tie Rod End

Delphi TA5098 is a steering tie rod end for the right outer position, built as a standard replacement for select Toyota applications. It combines a steel housing, coated finish, pre-greased construction, and a dust boot to support consistent steering response in daily driving.

Key Features

• Right outer steering tie rod end for select Toyota Prius C and Toyota Yaris applications
• Pre-greased design with no grease fitting required
• Steel housing with coated black finish for corrosion resistance
• Dust boot included with chloroprene rubber material
• Threaded stud design with clockwise thread direction on both ends
• Mounting hardware included
• Standard replacement part number TA5098

Application Details

This Delphi TA5098 tie rod end is engineered for the right outer steering position on 2012-2019 Toyota Prius C, 2006-2013 Toyota Yaris, and 2014 Toyota Yaris Japan Built models. It cross-references MOOG Chassis Products ES800312 for the same application. The part number TA5098 is also associated with Beck/Arnley 101-5407 for cross-reference purposes.

Delphi applies OE-focused dimensional and material analysis to help maintain proper fit between the original steering geometry and the aftermarket replacement. The component is tested across extreme temperature ranges and salt-spray exposure to reflect demanding undercar conditions. For Toyota Prius C and Toyota Yaris steering service, TA5098 provides a direct replacement option for the right outer tie rod end location.

Common Repair Uses

• Restoring loose or imprecise steering feel
• Replacing a worn outer tie rod end with play in the joint
• Addressing steering wheel wander or poor straight-line tracking
• Correcting front-end noise caused by tie rod wear
• Replacing a damaged dust boot or corroded steering joint

Installation Notes

Verify the right outer position before installation and confirm thread direction, thread diameter, and stud dimensions against the original part. After replacement, a professional wheel alignment is required to set toe and protect tire wear. This part is pre-greased and does not use a grease fitting, so no routine greasing is needed.

Quality Assurance

Delphi builds this steering tie rod end using OE-based engineering methods and material checks to support fitment accuracy and durability. The part is exposed to temperature and corrosion testing during development to reflect real-world steering demands.