Delphi TA5240 Steering Tie Rod End - Inner

Delphi TA5240 Steering Tie Rod End

Delphi TA5240 is a straight steering tie rod end built for front inner steering applications on select Cadillac models. It uses a high-strength steel housing, steel tie rod material, and a pre-greased design to support consistent steering response and service life.

Compatible with 2008-2014 Cadillac CTS inner steering applications and 2010-2011 Cadillac STS inner steering applications, this Delphi tie rod end is built to match OE dimensional and material requirements. The TA5240 part number is a direct reference for shoppers looking for a steering tie rod end for Cadillac CTS and Cadillac STS front inner service.

Key Features

• Straight steering tie rod end for inner front steering positions
• High-strength steel housing with coated finish
• Pre-greased for initial service readiness
• Adjustable design for steering linkage setup
• Male-to-male end configuration
• Clockwise thread direction on both ends
• Mounting hardware included
• Polyoxymethylene (POM) bearing material

Detailed Description

Delphi applies OE-focused engineering to its aftermarket steering portfolio, and the TA5240 reflects that approach with dimensional and material analysis aimed at proper fit and function. The part is tested for extreme temperature exposure and salt spray resistance to evaluate durability in demanding conditions. For drivers servicing Cadillac CTS or Cadillac STS steering components, Delphi TA5240 provides a standard replacement option for inner tie rod service where precise steering linkage geometry matters.

This part cross-references MOOG Chassis Products EV800711 for the same application.

What It Helps Address

• Excessive steering play at the inner tie rod connection
• Loose or imprecise steering feel
• Clunking or knocking from worn steering linkage components
• Uneven front tire wear caused by steering alignment issues
• Steering response problems related to worn inner tie rod ends

Installation Notes and Tips

Verify vehicle application by year, make, model, and inner steering position before installation. After replacement, perform a professional wheel alignment to restore steering geometry. Inspect related steering components, including outer tie rod ends and boots, while the system is apart. The TA5240 is listed for front left inner and front right inner use depending on the vehicle application, so confirm the correct side and position for your Cadillac CTS or Cadillac STS.

Quality Assurance

Delphi states that this steering component is built using OE expertise and validated through temperature and corrosion testing, including exposure below -40 degrees C, above 120 degrees C, and extended salt spray testing. The TA5240 is a standard replacement part engineered to align with OE and aftermarket dimensional requirements.