Delphi TA5271 Steering Tie Rod End - Inner

Delphi TA5271 Inner Tie Rod End

Delphi TA5271 is an inner steering tie rod end built for OE-style replacement performance in classic Ford and Mercury applications. It is a direct-fit steering component for 1970-1973 Mercury Montego, 1971-1973 Ford Mustang, and 1971-1973 Mercury Cougar inner steering service.

Key Features

• OE-focused steering replacement from Delphi
• Inner tie rod end for steering linkage service
• Steel housing and steel tie rod construction
• Pre-greased with grease fitting included
• Dust boot included for added joint protection
• Coated black finish for corrosion resistance
• Bent design with threaded stud construction
• Mounting hardware included
• Standard replacement grade

Detailed Description

The Delphi TA5271 steering tie rod end is engineered for inner steering applications where precise linkage movement and durable joint construction matter. Delphi applies OE dimensional and material analysis to help ensure proper fit and compatibility, and this part is tested across extreme temperature ranges and salt-spray exposure to validate durability in demanding conditions. It features a pre-greased, greaseable design with a dust boot and grease fitting to support long-term steering service.

Compatible With 1971-1973 Ford Mustang, inner steering; 1971-1973 Mercury Cougar, inner steering; and 1970-1971 Mercury Montego, inner steering. This Delphi TA5271 tie rod end is a practical choice when replacing worn steering linkage components on classic Mustang and Cougar platforms.

This part cross-references MOOG Chassis Products DS791 for the same application.

What It Helps Address

• Loose or imprecise steering response
• Clunking or play in the inner steering linkage
• Uneven front-end steering feel caused by worn tie rod joints
• Grease loss or contamination at the steering joint
• Corrosion-related wear in exposed steering components

Installation Notes and Tips

Verify inner position, thread direction, and thread size before installation. The TA5271 uses a male/male configuration with a bent body, so confirm alignment against the original part before assembly. After installation, inspect toe settings and perform a professional front-end alignment to restore steering geometry.

Quality Assurance

Delphi builds this steering component using OE-focused engineering and validation methods. The part is exposed to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray testing, to support durability in real-world steering service.